Purchase UBA2051(A;C), In-stock UBA2051(A;C) From SeekIC.
Part Number: UBA2051(A;C)
Description: The ICs UBA2050, UBA2050A, UBA2051, UBA2051A and UBA2051C contain all the functions needed to build a ...
- Table of contents:
UBA2051(A;C)
-
Suppliers
DataSheet
General Description
UBA2051(A;C) General Description
The ICs UBA2050, UBA2050A, UBA2051, UBA2051A and UBA2051C contain all the functions needed to build a fully electronic telephone set.
In many places in the text, figures and tables, the description is not applicable for all the five types, but only for one or two or for a combination. These combinations will be referred to by means of short denotations as given in Table 1.
Table 1 Denotations of types
|
DENOTATION |
TYPES |
| UBA2050x | UBA2050; UBA2050A |
| UBA2051x | UBA2051; UBA2051A; UBA2051C |
| UBA205x | UBA2050; UBA2051 |
| UBA2050xA | UBA2050A; UBA2051A |
| UBA205xx | all five types |
The devices incorporate a speech/transmission part, a dialler part and a ringer part. By offering a wide range of possible adaptations for each part, the UBA205xx applications can be easily adapted to meet different requirements.
Speech/transmission part
The speech/transmission part performs all transmission and line interface functions required in fully electronic telephone sets. It performs electronic switching between transmission and dialling. The IC operates at a DC voltage down to 1.45 V (with reduced performance) to facilitate the use of telephone sets connected in parallel.When the line current is high enough, a fixed amount of current is derived from pin LN in order to create a supply point at pin VDD. The voltage at pin VDD is regulated at 3.3 V to supply the dialler and ringer parts and peripheral circuits.
Dialler part
The dialler and ringer parts of the IC are responsible for the system control, system settings and the generation and detection of various signals.The dialler offers a 32-digit last number redial function.
The UBA2051x offers in addition 13 memories (3 direct + 10 indirect) of 21 digits.During pulse dialling the DMO output of the UBA205x can be used to decrease the line voltage. During tone dialling the LED output of the UBA205xA is used to indicate DTMF dialling. A keytone is available if a valid key is pressed for the types UBA2050x and UBA2051C.
Ringer part
The ringer part offers a discriminator input which enables the MDY/TONE output as soon as a valid ring frequency is detected. It offers a choice of 4 different 3-tone melodies and a 4-level volume control, both programmable via the keyboard. An external very low cost ringer output stage for a buzzer is needed. Stabilized supply (VDD) during ringer mode for dialler and ringer part is included.
UBA2051(A;C) Maximum Ratings
|
SYMBOL |
PARAMETER |
CONDITIONS |
MIN. |
MAX. |
UNIT |
| Ptot | total power dissipation | RSLPE =20 note 1 |
- |
625 |
mW |
| Tstg | storage temperature |
-40 |
+125 |
°C | |
| Tamb | ambient temperature |
-25 |
+75 |
°C | |
| Tj | junction temperature |
- |
125 |
°C | |
| Speech/transmission part | |||||
| VLN | positive continuous voltage on pin LN |
GND - 0.4 |
12 |
V | |
| VLN(R) | repetitive voltage on pin LN during switch-on or line interruption |
GND - 0.4 |
13.2 |
V | |
| ILN | line current | RSLPE = 20 ; note 2 |
- |
140 |
mA |
| VCC | supply voltage for the speech/transmission part and peripherals |
GND - 0.4 |
12 |
V | |
| VDD | stabilized supply voltage for the dialler and ringer parts |
IDD 75 mA |
GND - 0.4 |
3.6 |
V |
| IDD | input current at pin VDD for the dialler and ringer parts |
Iline = 0 mA |
- |
75 |
mA |
| Vn | voltage on pins SLPE, IR, REG, AGC, DTMF, RX, QR, GAR, MIC+ and MIC- |
GND - 0.4 |
VCC+0.4 |
V | |
| Dialler and ringer parts | |||||
| Vn | voltage on pins 8 to 21 |
GND - 0.4 |
VDD+0.4 |
V | |
| In | DC sink/source current for pins 8 to21 |
-10 |
+10 |
mA | |
1. Calculated for Tamb = 75 °C and Tj = 125 °C.
2. Mostly dependent on the maximum required ambient temperature and on the voltage between pins LN and SLPE
(see Fig.31).
UBA2051(A;C) Features
Speech/transmission part
` Low DC line voltage; operates down to 1.45 V (excluding voltage drop over external polarity guard)
` Line voltage regulator with adjustable DC voltage
` Regulated 3.3 V supply (VDD) for the dialler part and peripherals compatible with:
Speech mode
Ringer mode
Trickle mode.
` Unregulated supply (VCC) for the transmission part and peripherals
` Transmit stage with:
Microphone amplifier with symmetrical high-impedance inputs
DTMF input with confidence tone on receive output.
` Receive stage with:
Receive amplifier with asymmetrical output
Earpiece amplifier with adjustable gain (and gain boost facility) for all types of earpieces.
` AGC: line loss compensation for microphone and receive amplifiers.
Dialler part
` Last Number Redial (LNR) (32 digits)
` Pulse dialling:
10 PPS and 20 PPS (resistor option)
M/B 2 : 3 and 1 : 2 (resistor option).
` DTMF timing:
Manual dialling with minimum duration for bursts and pauses (85/85 ms)
Calibrated timing during redialling (85/85 ms).
` Pulse or tone mode select at start-up (resistor option)
` Flash function (600, 300, 98 and 80 ms) (resistor options)
` Access pause time 2.0 and 3.6 s (resistor option);access pauses in series are possible
` [*/T] key (for mixed mode dialling) or separate [P ® T] key
` Repertory memory integrity check
` Keytone generation (only UBA2050, UBA2050A and UBA2051C)
` Dial Mode Output (DMO) function during pulse dialling and flash function (only UBA2050 and UBA2051)
` LED output for DTMF dialling indication (only UBA2050A and UBA2051A)
` Function keys:
[LNR/P], [R] and [P ® T]
[STORE], [MEM], [M1], [M2] and [M3] (only UBA2051, UBA2051A and UBA2051C).
` Resistor options:
[*/T] key definition (MMS)
Pulse or Tone mode Selection (PTS)
Flash Time Selection (FTSA and FTSB)
Make/Break ratio Selection (MBS)
Pulses Per Second (PPS)
Access Pause Time (APT).
` 13 repertory numbers (only UBA2051, UBA2051A and UBA2051C):
3 direct memories (21 digits)
10 indirect memories (21 digits).
` Supply and temperature independent tone output
` On-chip DTMF filtering for low output distortion ("CEPT CS 203" compatible)
` On-chip oscillator suitable for low-cost 3.579545 MHz quartz crystal or ceramic resonator
` Uses standard single-contact keyboard
` Keyboard entries fully debounced.
Ringer part
` Ringer input frequency discrimination
` 3-tone ringer with 4 programmable melodies (selectable via keyboard by keys [1] to [4])
` 4-level volume control (selectable via keyboard by keys [5] to [8]).
UBA2051(A;C) Connection Diagram
UBA1702
PDF/DataSheet Download
- Datasheet: UBA1702
- File Size: 182782 KB
- Manufacturer: PHILIPS [Philips Semiconductors]
- Click here to Download
- ·UBA1702A
- PHILIPS [Philips Semiconductors]
- Line interrupter driver and ringer
- 182782 KB
- ·UBA1702AT
- PHILIPS [Philips Semiconductors]
- Line interrupter driver and ringer
- 182782 KB
- ·UBA1702T
- PHILIPS [Philips Semiconductors]
- Line interrupter driver and ringer
- 182782 KB
- ·UBA1706
- PHILIPS [Philips Semiconductors]
- Cordless telephone line interface
- 202151 KB
- ·UBA1706TS
- PHILIPS [Philips Semiconductors]
- Cordless telephone line interface
- 202151 KB
- ·UBA1707
- PHILIPS [Philips Semiconductors]
- Cordless telephone, answering machine line interface
- 251404 KB
- ·UBA1707T
- PHILIPS [Philips Semiconductors]
- Cordless telephone, answering machine line interface
- 251404 KB
- ·UBA1707TS
- PHILIPS [Philips Semiconductors]
- Cordless telephone, answering machine line interface
- 251404 KB
UBA2051(A;C) Relative Products
UBA2050(A)
The ICs UBA2050, UBA2050A, UBA2051, UBA2051A and UBA2051C contain all the functions needed to build a fully electronic telephone set.In many places in the text, figures and tables, the description is not applicable for all the five types, butonly for one or ...
UBA2033TS/N2,118
IC DRIVER FULL BRIDGE 28-SSOP
UBA2033
The UBA2033 is a high voltage monolithic integrated circuit made in the EZ-HV SOI process. The circuit is designed for driving the MOSFETs in a full bridge configuration. In addition, it features a disable function, an internal adjustable oscillator and an e...
-
UBA2032TS/N3,118
IC DRIVER FULL BRIDGE 28-SSOP
-
UBA2032TS/N2,118
IC DRIVER FULL BRIDGE 28-SSOP
UBA2032T/N2,118
IC DRIVER FULL BRIDGE SO-24
Hotspot Suppliers Product
TIM-LC-0-000-1
Price: 8.5-10.5 USD
ultra-low power OEM GPS module, 3V, 4 Hz, 50 mA, 10 dBm, TIM-LC-0-000-1
TC74HC237AF
Price: 0.28-0.3 USD
decoder address latch, SOP, 4mA
P4M900G
Price: 11.95-12.05 USD
Integrated Circuits, BGA
AOT430
Price: 0.5-1 USD
MOSFET N-CH, 75V 80A, TO-220
LT1613CS5#TRPBF
Price: 0.35-0.46 USD
5-lead SOT-23, current mode, DC/DC converter, –0.4V to 36V, Low ShutdowCurrent
LM124J
Price: 0.3-4 USD
Operational Amplifier, DIP, 10 to 0.1mA
TSC80251G2D-16CB
Price: 1-10 USD
B/16-BIT, MICROCONTROLLER, PLCC44
LQ084V1DG22
Price: 0.1-1 USD
color active matrix LCD, Sharp Electrionic Components, LQ084V1DG22
BMA8282PLABA-001
Price: 1-2 USD
TOP, BMA8282PLABA-001, Philips Electronics India Limited, Integrated Circuits (ICs)
ADSP-2188N BST-320
Price: 4.66-5.5 USD
DSP Microcomputer, qfp, –0.3 V to +2.2 V, 3-Bus Architecture, Low Power Dissipation
OPA2336PG4
Price: 2.07-2.1 USD
CMOS operational amplifier, 8DIP, 100kHz, 5mA, 2.3 V ~ 5.5 V, RoHS Compliant
AD652AQ
Price: 7-8 USD
Synchronous Voltage-to-Frequency Converter, MONO, 5V, 16CDIP, Full-Scale Frequency
