CMCPCI101QS, CMCPCI101TS, CMCPCI102B Selling Leads, Datasheet
MFG:SOP-28 Package Cooled:CMD D/C:02+
CMCPCI101QS, CMCPCI101TS, CMCPCI102B Datasheet download

Part Number: CMCPCI101QS
MFG: SOP-28
Package Cooled: CMD
D/C: 02+
MFG:SOP-28 Package Cooled:CMD D/C:02+
CMCPCI101QS, CMCPCI101TS, CMCPCI102B Datasheet download

MFG: SOP-28
Package Cooled: CMD
D/C: 02+
Want to post a buying lead? If you are not a member yet, please select the specific/related part number first and then fill the quantity and your contact details in the "Request for Quotation Form" on the left, and then click "Send RFQ".Your buying lead can then be posted, and the reliable suppliers will quote via our online message system or other channels soon.
TOP
PDF/DataSheet Download
Datasheet: CMC7101A
File Size: 499887 KB
Manufacturer:
Download : Click here to Download
PDF/DataSheet Download
Datasheet: CMC7101A
File Size: 499887 KB
Manufacturer:
Download : Click here to Download
PDF/DataSheet Download
Datasheet: CMCPCI102B
File Size: 227985 KB
Manufacturer: CALMIRCO [California Micro Devices Corp]
Download : Click here to Download
The CMCPCI102BT/BR is a 10-channel backplane interface/termination IC specifically designed for CompactPCI redundant system-slot cards. The CMCPCI102BT/BR allows CompactPCI boards to interface to the backplane and provides the versatility to use system cards in any slot (system or peripheral). Per the CompactPCI specification, the CMCPCI102BT/BR provides a 10Ω termination resistor for each channel to terminate the transmission line stub on the board. An integral series switch and associated control signal (SW_EN) permits connection/disconnection of the channel, so that the device side of the circuit may be isolated from the backplane side.
The CompactPCI standard requires system boards to be hot-swappable. To accommodate this requirement, the CMCPCI102BT/BR features a switched 10kΩ resistor connected to the 1V Precharge Supply Voltage. If the precharge enable pin (P_EN) is asserted, then the 10kΩ pull-up resistors are connected to precharge the circuits.
In addition, a system board requirement mandates either a 1.0kΩ pull-up resistor or a 2.7kΩ resistor connected to VIO. CompactPCI slot cards must work in either 3.3V or 5V systems, hence the need for both 2.7kΩ and 1kΩ resistors. If the 3_EN pin is logic high, the 2.7kΩ resistor is used as the pull-up. If the 5_EN pin is logic high, the 1kΩ resistor is used.
The CMCPCI102BT/BR integrates all these functions in a low-profile 28-pin TSSOP package and is available with optional lead-free finishing.
Note: Some of the devices listed here have suggested replacements available. Please see additional information at the end of this page.

