Want to post a buying lead? If you are not a member yet, please select the specific/related part number first and then fill the quantity and your contact details in the "Request for Quotation Form" on the left, and then click "Send RFQ".Your buying lead can then be posted, and the reliable suppliers will quote via our online message system or other channels soon.
The M41T00S Serial Access TIMEKEEPER® SRAM is a low power Serial RTC with a built-in 32.768kHz oscillator (external crystal controlled). Eight bytes of the SRAM (see Table 2., page 11) are used for the clock/calendar function and are configured in binary coded decimal (BCD) format. Addresses and data are transferred serially via a two line, bi-directional I2C interface. The built-in address register is incremented automatically after each WRITE or READ data byte.
The M41T00S has a built-in power sense circuit which detects power failures and automaticallyswitches to the battery supply when a power failure occurs. The energy needed to sustain the clock operations can be supplied by a small lithium button supply when a power failure occurs. The eight clock address locations contain the century, year, month, date, day, hour, minute, and second in 24 hour BCD format. Corrections for 28, 29 (leap year - valid until year 2100), 30 and 31 day months are made automatically.
The M41T00S is supplied in an 8-pin SOIC.
M41T00S Maximum Ratings
Symbol
Parameter
Value
Unit
TSTG
Storage Temperature (VCC Off, Oscillator Off)
SOIC
55 to 125
VCC
Supply Voltage
0.3 to 7
V
TSLD
Lead Solder Temperature for 10 Seconds
Lead-free lead finish(1)
260
Standard (SnPb) lead finish(2,3)
240
VIO
Input or Output Voltages
-0.3 to VCC + 0.3
V
IO
Output Current
20
mA
PD
Power Dissipation
1
W
Note: 1. For SO8 package, Lead-free (Pb-free) lead finish: Reflow at peak temperature of 260°C (total thermal budget not to exceed 245°C for greater than 30 seconds). 2. For SO8 package, standard (SnPb) lead finish: Reflow at peak temperature of 240°C (total thermal budget not to exceed 180°C for between 90 to 150 seconds). 3. The SOX18 package has Lead-free (Pb-free) lead finish, but cannot be exposed to peak reflow temperature in excess of 240°C (use same reflow profile as standard (SnPb) lead finish). CAUTION: Negative undershoots below 0.3 volts are not allowed on any pin while in the Battery Back-up Mode
M41T00S Features
` 2.0 TO 5.5V CLOCK OPERATING VOLTAGE ` COUNTERS FOR SECONDS, MINUTES, HOURS, DAY, DATE, MONTH, YEAR, AND CENTURY ` SOFTWARE CLOCK CALIBRATION ` AUTOMATIC SWITCH-OVER AND DESELECT CIRCUITRY (FIXED REFERENCE) VCC = 2.7 to 5.5V 2.5V VPFD 2.7V ` SERIAL INTERFACE SUPPORTS I2C BUS (400kHz PROTOCOL) ` LOW OPERATING CURRENT OF 300A ` OSCILLATOR STOP DETECTION ` BATTERY OR SUPER-CAP BACK-UP ` OPERATING TEMPERATURE OF 40 TO 85°C ` ULTRA-LOW BATTERY SUPPLY CURRENT OF 1A