ST1305, ST130A, ST130B Selling Leads, Datasheet
MFG:STM Package Cooled:DIP-8 D/C:92+
ST1305, ST130A, ST130B Datasheet download

Part Number: ST1305
MFG: STM
Package Cooled: DIP-8
D/C: 92+
MFG:STM Package Cooled:DIP-8 D/C:92+
ST1305, ST130A, ST130B Datasheet download

MFG: STM
Package Cooled: DIP-8
D/C: 92+
Want to post a buying lead? If you are not a member yet, please select the specific/related part number first and then fill the quantity and your contact details in the "Request for Quotation Form" on the left, and then click "Send RFQ".Your buying lead can then be posted, and the reliable suppliers will quote via our online message system or other channels soon.
TOP
PDF/DataSheet Download
Datasheet: ST1305
File Size: 40947 KB
Manufacturer: STMICROELECTRONICS [STMicroelectronics]
Download : Click here to Download
PDF/DataSheet Download
Datasheet: ST1.0-127-05L
File Size: 126326 KB
Manufacturer:
Download : Click here to Download
PDF/DataSheet Download
Datasheet: ST1.0-127-05L
File Size: 126326 KB
Manufacturer:
Download : Click here to Download
The ST1305 is a 192-bit EEPROM device with associated security logic to control memory access. The circuit includes counting capabilities and thus is very well adapted to prepaid card applications.
The ST1305 is protected by hard-wired security logic and special fuses. The memory is arranged as a matrix of 24x8 cells, accessed in a serial bit-wise fashion for reading and programming, and in a byte-wise fashion for internal erasing.
The device recognises three commands issued via the RST and CLK pins (as described in the full data sheet):
RESET: to reset the internal address register to 00d
READ: to increment the internal address register, and read the data bit at that address
PROG: to program the bit at the current address.
The device offers two distinct configurations:
ISSUER: for the card manufacturer, allowing special data to be written to the chip, during initialisation
USER: for the end user of the card, restricting access to the chip.
Before delivery, from ST to the card issuer, the device is placed in the ISSUER configuration. This operation is performed by blowing the "test fuse".
