21-28391-02, 21285, 2128500-R Selling Leads, Datasheet
MFG:HARR Package Cooled:PLCC D/C:99+
21-28391-02, 21285, 2128500-R Datasheet download

Part Number: 21-28391-02
MFG: HARR
Package Cooled: PLCC
D/C: 99+
MFG:HARR Package Cooled:PLCC D/C:99+
21-28391-02, 21285, 2128500-R Datasheet download

MFG: HARR
Package Cooled: PLCC
D/C: 99+
Want to post a buying lead? If you are not a member yet, please select the specific/related part number first and then fill the quantity and your contact details in the "Request for Quotation Form" on the left, and then click "Send RFQ".Your buying lead can then be posted, and the reliable suppliers will quote via our online message system or other channels soon.
TOP
PDF/DataSheet Download
Datasheet: 21-0056C
File Size: 17872 KB
Manufacturer: MAXIM [Maxim Integrated Products]
Download : Click here to Download
PDF/DataSheet Download
Datasheet: 212
File Size: 169204 KB
Manufacturer: Holtek
Download : Click here to Download
PDF/DataSheet Download
Datasheet: 212
File Size: 169204 KB
Manufacturer: Holtek
Download : Click here to Download
Intel Semiconductor's 21285 is a single-chip interface between an SA-110 microprocessor, synchronous DRAM memory (SDRAM), read-only memory (ROM), and the PCI bus. It is designed to support the following three modes of operation:
• PCI-based SA-110 computer. In this configuration, the SA-110 processor is the host Intelprocessor. It configures all PCI peripherals in the system.
• Attached processor. In this configuration, the SA-110 processor system interfaces directly to the host system PCI bus. The 21285 is configured by the host processor in the system.
• Intelligent add-in card. In this configuration, the SA-110 processor controls a PCI-based subsystem that is designed to be plugged into a host system PCI slot. Normally, a PCI-to-PCI bridge device interfaces the oncard PCI system to the host PCI system. The SA-110 processor typically configures the devices on the add-in card. Alternatively, these devices and the 21285 can be configured by the host processor in the system.
The SA-110 bus must be configured for enhanced mode (SA-110 signal CONFIG is high), address pipeline enabled (SA-110 signal APE tied high), and asynchronous bus clock (SA-110 signal SnA tied low). The SA-110 bus interface and PCI interface clocks are asynchronous to each other (all synchronization is done within the 21285). However, the SA-110 bus clock frequency must always be greater than or equal to the PCI bus clock frequency.
|
Parameter |
Minimum |
Maximum |
| Junction temperature,Tj |
- |
125 |
| Supply Voltage, Vdd |
- |
3.9 V |
| Maximum voltage applied to signal pins |
- |
5.5 V |
| Maximum power PWC |
- |
1.77 W @ 33 MHz |
| Storage temperature range, Tstg |
-55 |
125 |
