Want to post a buying lead? If you are not a member yet, please select the specific/related part number first and then fill the quantity and your contact details in the "Request for Quotation Form" on the left, and then click "Send RFQ".Your buying lead can then be posted, and the reliable suppliers will quote via our online message system or other channels soon.
The OPA681 sets a new level of performance for broadband current feedback op amps. Operating on a very low 6mA supply current, the OPA681 offers a slew rate and output power normally associated with a much higher supply current.
A new output stage architecture delivers a high output current with minimal voltage headroom and crossover distortion. This gives exceptional single-supply operation.
Using a single +5V supply, the OPA681 can deliver a 1V to 4V output swing with over 100mA drive current and 150MHz bandwidth. This combination of features makes the OPA681 an ideal RGB line driver or single-supply ADC input driver.
The OPA681's low 6mA supply current is precisely trimmed at 25. This trim, along with low drift over temperature,guarantees lower guaranteed maximum supply current than competing products. System power may be further reduced by using the optional disable control pin. Leaving this disable pin open, or holding it high, gives normal operation. If pulled low, the OPA681 supply current drops to less than 320mA while the output goes into a high impedance state. This feature may be used for either power savings or for video MUX applications.
OPA681 Maximum Ratings
Power Supply ..............................................................................±6.5VDC Internal Power Dissipation(1) ............................ See Thermal Information Differential Input Voltage ................................................................±1.2V Input Voltage Range ..........................................................................±VS Storage Temperature Range: P, U, N ............................ 40 to +125 Lead Temperature (soldering, 10s) .............................................. +300 Junction Temperature (TJ ) ........................................................... +175 NOTE:: (1) Packages must be derated based on specified JA. Maximum TJ must be observed.