342MPLF

FIELD PROGRAMMABLE DUAL O
The ICS342 is a low-cost, dual-output, VersaClock? supported, field programmable clock synthesizer. The ICS342 can generate an two output frequencies from 250 kHz to 200 MHz, using up to two independently configurable PLLs. The outputs may employ Spread Spectrum techniques to reduce system electro-magnetic interference (EMI).
Using IDT VersaClock software to configure the PLL and output, the ICS342 contains a One-Time Programmable (OTP) ROM to allow field programmability. Programming features include two selectable configuration registers. The device employs Phase-Locked Loop (PLL) techniques to run from a standard fundamental mode, inexpensive crystal, or clock. It can replace multiple crystals and oscillators, saving board space and cost.
The device also has a power-down feature that tri-states the clock outputs and turns off the PLLs when the PDTS pin is taken low.
The ICS342 is also available in factory programmed custom versions for high-volume applications.

8-pin SOIC package

Highly accurate frequency generation

M/N Multiplier PLL: M = 1...2048, N = 1...1024

Output clock frequencies up to 200 MHz

Two ROM locations for frequency and spread selection

Spread spectrum capability for lower system EMI

Center or Down spread up to 4% total

Selectable 32 kHz or 120 kHz modulation

Input crystal frequency of 5 to 27 MHz

Input clock frequencies from 2 to 50 MHz

Operating voltage of 3.3 V

Advanced, low-power CMOS process

For one output clock, use the ICS341. For three output clocks, see the ICS343. For more than three outputs, see the ICS345 or ICS348

Available in Pb (lead) free package
click here for VersaClock Software page