Features: • Voltage Regulator VIN Range: 4.5V to 6V• Complete Power Integration▪ Integrated Load Switches to Power Converters from AC Adapter or Battery Automatically• Low Standby Current▪ 200A (typ) w/LDO1, LDO2 and LDO5 Active, No Load• One Step-Down Buck Conv...
AAT3601: Features: • Voltage Regulator VIN Range: 4.5V to 6V• Complete Power Integration▪ Integrated Load Switches to Power Converters from AC Adapter or Battery Automatically• Low St...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Symbol |
Description |
Value |
Units |
VIN |
Input Voltage, CHGIN, BAT |
-0.3 to 6.5 |
V |
Power and Logic Pins |
Maximum Rating |
VIN + 0.3 |
V |
TJ |
Operating Junction Temperature Range |
-40 to 150 |
|
Ts |
Storage Temperature Range |
-65 to 150 |
|
TLEAD |
Maximum Soldering Temperature (at leads, 10 sec) |
300 |
The AAT3601 is a member of AnalogicTech's Total Power Management ICTM (TPMICTM) product family. It contains a single-cell Lithium Ion/Polymer battery charger, a fully integrated step-down converter and 5 low dropout (LDO) regulators. The device also includes 2 load switches for dynamic power path/sleep mode operation, making it ideal for small portable short-range communications enabled mobile devices and telephones.
The battery charger is a complete thermally regulated constant current/constant voltage linear charger. It includes an integrated pass device, reverse blocking protection, high accuracy current and voltage regulation, charge status, and charge termination. The charging current and the charge termination current as well as recharge voltage are programmable with either an external resistor and/or by a standard I2C interface.
The step-down DC/DC converter AAT3601 is integrated with internal compensation and operates at a switching frequency of 1.5MHz, thus minimizing the size of external components while keeping switching losses low and efficiency greater than 95%. All LDO output voltages are programmable using the I2C interface.
The five LDOs offer 60dB power supply rejection ratio (PSRR) and low noise operation making AAT3601 suitable for powering noise-sensitive loads. The LDOs and DC/DC converter are separated into Permanent-Enabled (PE) and Non-Permanent (NP) enabled supplies.
All six voltage regulators operate with low quiescent current.The total no load current when the 3 PE LDOs are enabled is only 200A.
The device includes a watchdog timer input and two reset outputs for the watchdog and LDO regulation. The device also can be programmed through a standard I2C inter face.
The AAT3601 is available in a thermally enhanced low profile 5x5x0.8mm 36-pin TQFN package.