Purchase AT90RF135602, In-stock AT90RF135602 From SeekIC.
Part Number: AT90RF135602
Description: AT90RF135602 is an ultra small footprint low-cost Radio Frequency Identification (RFID) reader develop...
- Table of contents:
AT90RF135602
-
Suppliers
DataSheet
General Description
AT90RF135602 General Description
AT90RF135602 is an ultra small footprint low-cost Radio Frequency Identification (RFID) reader developed with Innovision Research & Technology plc to address multi-protocol 13.56 MHz RFID applications.
It is optimised for use with the established ISO/IEC14443 type A standard and is available in Low-profile Ball Grid Array (LBGA).
The LBGA incorporates a custom transceiver front-end along with a protocol & communications controller. It requires only an external crystal and minimal external passive components to interface to the reader antenna.
Protocols are software defined and hence configurable.
AT90RF135602 Maximum Ratings
I = industrial ........................................................-40°C to 85°C
Operating Temperature................................... -30°C to + 80°C
StorageTemperature .......................................-40°C to + 85°C
Voltage on VCC to VSS ......................................-0.5V to + 6.5V
Voltage on Any Pin to VSS..........................-0.5V to VCC + 0.5V
Power Dissipation Typical........................................... 120 mW
Power Dissipation Max ............................................... 300 mW
Note: Stresses at or above those listed under "Absolute
Maximum Ratings" may cause permanent damage to
the device. This is a stress rating only and functional
operation of the device at these or any other conditions
above those indicated in the operational
sections of this specification is not implied. Exposure
to absolute maximum rating conditions may affect
device reliability.
Power dissipation is based on the maximum allowable
die temperature and the thermal resistance of
the package.
Operating Temperature................................... -30°C to + 80°C
StorageTemperature .......................................-40°C to + 85°C
Voltage on VCC to VSS ......................................-0.5V to + 6.5V
Voltage on Any Pin to VSS..........................-0.5V to VCC + 0.5V
Power Dissipation Typical........................................... 120 mW
Power Dissipation Max ............................................... 300 mW
Note: Stresses at or above those listed under "Absolute
Maximum Ratings" may cause permanent damage to
the device. This is a stress rating only and functional
operation of the device at these or any other conditions
above those indicated in the operational
sections of this specification is not implied. Exposure
to absolute maximum rating conditions may affect
device reliability.
Power dissipation is based on the maximum allowable
die temperature and the thermal resistance of
the package.
AT90RF135602 Features
• Contactless Interface
Reads and Writes Passive RFID Tags in the Unlicensed 13.56 MHz Band
Employs ISO/IEC14443 Type A Modulation Schemes
Autonomous Operation Capability (can scan and read tags without host
intervention i.e. only passes data following successful read/write operation)
Compatible with NFC Initiation Only Device User Has Control Over Initiation of all
RFID Based Services and Features
Read/write Operation Between 1 cm and 10 cm Read Range, Depending on
Reader/Tag Antenna Coil Sizes and Orientation Relative to the Reader
Collision Detection as Standard
Transparent Modes for Software Controlled Modulation Supports Maximum
Flexibility and Future Protocols
Fast Data Communication Rate of 106 kbit/s
Suitable for Operation with a Wide Variety of Antenna Coil Sizes and Form Factors
Four Software Adjustable Carrier Field Drive Levels
• Controller and Software
On-board Powerful Atmel AVR® RISC microcontroler, programmed with
Innovision® proprietary software.
Built in Self Test and Diagnostic Modes
Internal 8 MHz RC Oscillator for Micro or External Crystal Operation
• Host Interface
3-wire SPI Interface as Standard
Full Software Control via SPI bus at 115 Kbaud as Standard Interface
• Power Supply
Ultra Low Current Operation and Stand-by Sleep Mode Typically < 1 A
Ultra Low Voltage Operation: 2.7V - 3.3V
• Additional features
Packages: LBGA36
LBGA Requires Only an External Crystal, 10 Passives and the Reader Antenna Coil
Operating temperature range: -30°C to +80°C
Reads and Writes Passive RFID Tags in the Unlicensed 13.56 MHz Band
Employs ISO/IEC14443 Type A Modulation Schemes
Autonomous Operation Capability (can scan and read tags without host
intervention i.e. only passes data following successful read/write operation)
Compatible with NFC Initiation Only Device User Has Control Over Initiation of all
RFID Based Services and Features
Read/write Operation Between 1 cm and 10 cm Read Range, Depending on
Reader/Tag Antenna Coil Sizes and Orientation Relative to the Reader
Collision Detection as Standard
Transparent Modes for Software Controlled Modulation Supports Maximum
Flexibility and Future Protocols
Fast Data Communication Rate of 106 kbit/s
Suitable for Operation with a Wide Variety of Antenna Coil Sizes and Form Factors
Four Software Adjustable Carrier Field Drive Levels
• Controller and Software
On-board Powerful Atmel AVR® RISC microcontroler, programmed with
Innovision® proprietary software.
Built in Self Test and Diagnostic Modes
Internal 8 MHz RC Oscillator for Micro or External Crystal Operation
• Host Interface
3-wire SPI Interface as Standard
Full Software Control via SPI bus at 115 Kbaud as Standard Interface
• Power Supply
Ultra Low Current Operation and Stand-by Sleep Mode Typically < 1 A
Ultra Low Voltage Operation: 2.7V - 3.3V
• Additional features
Packages: LBGA36
LBGA Requires Only an External Crystal, 10 Passives and the Reader Antenna Coil
Operating temperature range: -30°C to +80°C
AT90RF135602 Typical Application
• Passive read/write RFID tag applications operating in the unlicensed 13.56 MHz band
• Hand-held and low-power battery operated ISO/IEC 14443 type A read/writers
• Reader to reader inductive/Near Field Communications
• Hand-held and low-power battery operated ISO/IEC 14443 type A read/writers
• Reader to reader inductive/Near Field Communications
AT90RF135602
PDF/DataSheet Download
- Datasheet: AT90RF135602
- File Size: 806653 KB
- Manufacturer: ATMEL
- Click here to Download
- ·AT9
- Analog IC
- 55024 KB
- ·AT90-0001
- MACOM [Tyco Electronics]
- Digital Attenuator, 31.0 dB, 5-Bit, TTL Driver, DC-6.0 GHz
- 244970 KB
- ·AT90-0001-TB
- MACOM [Tyco Electronics]
- Digital Attenuator, 31.0 dB, 5-Bit, TTL Driver, DC-6.0 GHz
- 244970 KB
- ·AT90-0001TR
- MACOM [Tyco Electronics]
- Digital Attenuator, 31.0 dB, 5-Bit, TTL Driver, DC-6.0 GHz
- 244970 KB
- ·AT9001
- Advanced Semiconductor
- SILICON VARACTOR DIODE
- 25201 KB
- ·AT90-0106
- MACOM [Tyco Electronics]
- Digital Attenuator, 50 dB, 6-Bit, TTL Driver, DC-2.4 GHz
- 285857 KB
- ·AT90-0106-TB
- MACOM [Tyco Electronics]
- Digital Attenuator, 50 dB, 6-Bit, TTL Driver, DC-2.4 GHz
- 285857 KB
- ·AT90-0106TR
- MACOM [Tyco Electronics]
- Digital Attenuator, 50 dB, 6-Bit, TTL Driver, DC-2.4 GHz
- 285857 KB
AT90RF135602 Relative Products
AT90PWM81-16SQ
MCU AVR 8K FLASH LIGHTING SO-24
AT90PWM81-16SN
IC MCU AVR 8K FLASH ISP 20SOIC
AT90PWM81-16SF
IC MCU AVR 8K FLASH ISP 20SOIC
AT90PWM81-16MQ
MCU AVR 8K FLASH LIGHTING 32-QFN
AT90PWM81-16MN
IC MCU AVR 8K FLASH ISP 32QFN
-
AT90PWM81-16MF
IC MCU AVR 8K FLASH ISP 32QFN
Hotspot Suppliers Product
TDA12021H1/N1F01
Price: 4.45-5 USD
TDA12021H1/N1F01, QFP-128, NXP Semiconductors
NJM4558L
Price: 0.8-1.4 USD
dual operational amplifier, ZIP, ± 18 V, High Voltage Gain, 5MΩ
L7812
Price: 0.15-0.31 USD
POSITIVE VOLTAGE REGULATORS, TO-220, 35V Input Voltage, SHORT CIRCUIT PROTECTION, Internally Limit...
LM393
Price: 0.08-0.11 USD
dual differential comparator, LM393, –0.3 V to 36 V, 0.4 mA, Wide Range of Supply Voltage
SN74AHC244DW
Price: 0.4-1.2 USD
20SOIC, Tri-state, 2-V to 5.5-V, 250 mA , Texas Instruments, octal buffers/driver
LM358DR
Price: 0.04-0.1 USD
dual operational amplifier, DIP, +/-16, 32 V, 50mA, 2nA, 2mV, 100dB, low power
DM102A-4G1
Price: 1-50 USD
DM102A-4G1, SANYO LCD DIDSPLAY, Optoelectronics
LM2940S-5.0+
Price: 0.7-1.4 USD
positive voltage regulator, TO-263, 1A, 12V, LM2940S-5.0+, National Semiconductor
AT91SAM7X256B-AU
Price: 1-1 USD
AT91 ARM, Thumb-based Microcontroller, QFP100
TLC542IN
Price: 0.01-100 USD
8-BIT, analog-to-digital converters, 20-DIP, ±30 mA, 6.5 V, Built-In Self-Test Mode
FF150R12KS4
Price: 94-103 USD
62mm, C-Series module, with the fast IGBT2, high-frequency switching, MODULE
AD8131ARMZ-REEL7
Price: 0.67-0.8 USD
IC AMP DIFF LDIST 60MA 8MSOP - AD8131ARMZ-REEL7
