ATTINY13A-10SU

The ATTINY13A-10SU belongs to ATtiny13A family which is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATtiny13A achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.

The features of ATTINY13A-10SU can be summarized as (1)high performance, low power AVR 8-Bit Microcontroller; (2)advanced RISC architecture 120 powerful instructions most single clock cycle execution 32 x 8 general purpose working registers fully static operation up to 20 MIPS througput at 20 MHz; (3)high endurance non-volatile memory segments 1K Bytes of in-system self-programmable flash program memory 64 bytes EEPROM 64 bytes Internal SRAM write/erase cycles: 10,000 Flash/100,000 EEPROM data retention: 20 Years at 85°C/100 Years at 25°C (see page 6) programming lock for self-programming flash & EEPROM data security; (4)peripheral features one 8-bit timer/counter with prescaler and two PWM channels 4-channel, 10-bit ADC with internal voltage reference programmable watchdog timer with separate on-chip oscillator on-chip analog comparator; (5)special microcontroller features debugWIRE on-chip debug system in-system programmable via SPI Port external and internal interrupt sources low power idle, ADC noise reduction, and power-down modes enhanced power-on reset circuit programmable brown-out detection circuit with software disable function internal calibrated oscillator; (6)I/O and packages 8-pin PDIP/SOIC: six programmable I/O lines 10-pad MLF: six programmable I/O lines 20-pad MLF: six programmable I/O lines; (7)operating voltage: 1.8 5.5V; (8)speed grade: 0 4 MHz @ 1.8 5.5V 0 10 MHz @ 2.7 5.5V 0 20 MHz @ 4.5 5.5V; (9)industrial temperature range; (10)low power consumption active mode: 190 A at 1.8 V and 1 MHz idle mode: 24 A at 1.8 V and 1 MHz.

The ATTINY13A-10SU AVR is supported with a full suite of program and system development tools including: C Compilers, Macro Assemblers, Program Debugger/Simulators, and Evaluation kits. The device is manufactured using Atmel's high density non-volatile memory technology. The On-chip ISP Flash allows the Program memory to be re-programmed In-System through an SPI serial interface, by a conventional non-volatile memory programmer or by an On-chip boot code running on the AVR core.