Purchase IN24LC04B, In-stock IN24LC04B From SeekIC.
Part Number: IN24LC04B
Description: IN24LC04B/08B is a 4K-or 8K-bit Electrically Erasable PROM. The device is organized as two or four blo...
- Table of contents:
IN24LC04B
-
Suppliers
DataSheet
General Description
IN24LC04B General Description
IN24LC04B/08B is a 4K-or 8K-bit Electrically Erasable PROM. The device is organized as two or four blocks of 256 x 8 bit memory with a two wire serial interface. Low voltage design permits operation down to 2.5 volts with standby and active currents of only 5A and 1mA respectively. The IN24LC04B/08B also has a page-write capability for up to 16 bytes of data. The IN24LC04B/08B is available in the standard 8-pin DIP.
IN24LC04B Maximum Ratings
|
Parameter |
Value |
| VCC | 7.0 V |
| All inputs and outputs w.r.t.Vss | -0.3V to Vcc + 1.0V |
| Storage temperature | -65oC to +150oC |
| Ambient temp. with power applied | -40 to +85oC |
| Soldering temperature of leads (10 seconds) | +300oC |
| ESD protection on all pins | > 4 kV |
IN24LC04B Features
• Single supply with operation down to 2.5V
• Low power CMOS technology
- 1 mA active current typical
- 10 A standby current typical at 5.5V
- 5 A standby current typical at 3.0V
• Organized as two or four blocks of 256 bytes (2x256x8) and (4x256x8)
• Two wire serial interface bus, I2C compatible
• Schmitt trigger, filtered inputs for noise suppression
• Output slope control to eliminate ground bounce
• 100 kHz (2.5V) and 400 kHz (5V) compatibility
• Self-timed write cycle (including auto-erase)
• Page-write buffer for up to 16 bytes
• 2 ms typical write cycle time for page-write
• Hardware write protect for entire memory
• Can be operated as a serial ROM
• Factory programming (QTP) available
• ESD protection > 4,000V
• 1,000,000 ERASE/WRITE cycles guaranteed*
• Data retention > 200 years
• 8-pin DIP
• Temperature range -40 to +85 oC
• Low power CMOS technology
- 1 mA active current typical
- 10 A standby current typical at 5.5V
- 5 A standby current typical at 3.0V
• Organized as two or four blocks of 256 bytes (2x256x8) and (4x256x8)
• Two wire serial interface bus, I2C compatible
• Schmitt trigger, filtered inputs for noise suppression
• Output slope control to eliminate ground bounce
• 100 kHz (2.5V) and 400 kHz (5V) compatibility
• Self-timed write cycle (including auto-erase)
• Page-write buffer for up to 16 bytes
• 2 ms typical write cycle time for page-write
• Hardware write protect for entire memory
• Can be operated as a serial ROM
• Factory programming (QTP) available
• ESD protection > 4,000V
• 1,000,000 ERASE/WRITE cycles guaranteed*
• Data retention > 200 years
• 8-pin DIP
• Temperature range -40 to +85 oC
IN24LC04B Connection Diagram
IN24LC04B
PDF/DataSheet Download
- Datasheet: IN24LC04B
- File Size: 252219 KB
- Manufacturer: INTEGRAL [Integral Corp.]
- Click here to Download
- ·IN2418
- ETC [ETC]
- Telephone Tone Ringer with Bridge Diode
- 155844 KB
- ·IN2418N
- ETC [ETC]
- Telephone Tone Ringer with Bridge Diode
- 155844 KB
- ·IN24LC02B
- INTEGRAL [Integral Corp.]
- 2K 2.5V CMOS Serial EEPROMs
- 252008 KB
- ·IN24LC04
- INTEGRAL [Integral Corp.]
- 4K/8K 2.5V CMOS Serial EEPROMs
- 252219 KB
- ·IN24LC04BD
- INTEGRAL [Integral Corp.]
- 4K/8K 2.5V CMOS Serial EEPROMs
- 252219 KB
- ·IN24LC04BN
- INTEGRAL [Integral Corp.]
- 4K/8K 2.5V CMOS Serial EEPROMs
- 252219 KB
- ·IN24LC04D
- INTEGRAL [Integral Corp.]
- 4K/8K 2.5V CMOS Serial EEPROMs
- 252219 KB
- ·IN24LC04N
- INTEGRAL [Integral Corp.]
- 4K/8K 2.5V CMOS Serial EEPROMs
- 252219 KB
IN24LC04B Relative Products
IN24LC02B
IN24LC02B is a 2K-bit Electrically Erasable PROM. The device is organized as a single block of 256 x 8 bit memory with a two wire serial interface. Low voltage design permits operation down to 2.5volts with standby and active currents of only 5A and 1mA resp...
IN2418
The IN2418 tone ringer derives its power supply by rectifying the AC ringing signal. It uses this power to activate two tone generators. The two tone frequencies generated are switched by internal oscillator in a fast sequence and made audible across an outp...
IN1706N,D
3.3 and 5.0 Volt Micro Monitor IN1706N,D
IN1705N/D
Low power Micro Monitor Chip IN1705N/D
IN1705D
IN1705D microcircuit is purposed to check power supply and to start up microcontroller and microprocessor systems. It is applied to ensure regular standard operation of the circuit when the device is switched on\off and also when there is alarm emergency dro...
IN1705
The IN1705 is designed to control power supply and to start microcontroller and microprocessor systems. It is used for securing stable functioning of the system when starting and halting the device as well as in the case of the supply voltage drops. Manufact...
Hotspot Suppliers Product
2SK2225
Price: 4.5-4.8 USD
2SK2225, Silicon N Channel MOS FET, Renesas Technology Corp, TO-3PF, Channel dissipation 50 W
ATAR892W
Price: 0.629-1.56 USD
4-bit single-chip micro-controller, SSOP20, -0.3 to + 6.5 V, Very Low Sleep Current
SGA-7489Z A74Z
Price: 6-10 USD
amplifier, SOT89, 170mA
FMM5056VF
Price: 130-160 USD
MMIC amplifier, 5.8 to 7.2GHz, 12 V, 28.0 dBm, Hermetically Sealed Package
TB5R1LDWR
Price: 2-3 USD
quad differential receiver, 16-SOIC, 4.5 V ~ 5.5 V, RoHS Compliant, 8 kΩ
EKMM161VSN122MR35S
Price: 0.01-100 USD
large capacitance, aluminum electrolytic capacitor, 1200 uF, 160V, Non solvent-proof type
BMA8282PLABA-001
Price: 1-2 USD
TOP, BMA8282PLABA-001, Philips Electronics India Limited, Integrated Circuits (ICs)
KS8721SLI
Price: 0.65-0.75 USD
IC TXRX PHY 10/100 3.3V 48SSOP - KS8721SLI
NTB60N06G
Price: 0.3-0.5 USD
N-Channel, 60 V, 60 A, Power MOSFET, TO263, Surface Mount, Metal Oxide, low voltage, 2.4W
MAX1232
Price: 1-1 USD
microprocessor (uP) supervisory circuit, DIP, no external components, -1V to +7V
OPA552PA
Price: 2.14-2.38 USD
DIP-8, Wide supply range, ±30V, 12MHz, Wide output swing, low cost, op amp, high voltage, high-cur...
OPA2251PAG4
Price: 2.15-2.38 USD
micropower operational amplifier, 8DIP, 50mA, 2.7 V ~ 36 V, Through Hole, Rail-to-Rail
