LH1056

Absolute Maximum Ratings (TA=25)
Emitter
Reverse Voltage...............................................................6.0 V
Continuous Forward Current.......................................... 60 mA
Peak Forward Current (1ms)................................................1 A
Power Dissipation ........................................................100 mW
Derate Linearly from 25 .........................................1.3 mW/
Detector
Output Breakdown Voltage...........................................±350 V
Continuous Load Current............................................±100 mA
Total Power Dissipation.................................................500 mW
Derate Linearly from 25 ......................................See Figure 7
Package
Isolation Test Voltage ...........................................3750 VACRMS
Isolation Resistance
    V_IO=500 V, TA=25...................................................10¹²
    V_IO=500 V, TA=100.................................................10¹¹
Power Dissipation ..........................................................500 mW
Derate Linearly from 25 ...........................................2.5 mW/
Storage Temperature Range................................40 to +150 
Operating Temperature Range...............................40 to +85
Junction Temperature .........................................................100
Soldering Temperature, 2 mm from case, 10 sec.................260

The LH1056 is a single pole single throw (SPST), normally open (NO), solid state relay. The relay can control AC or DC loads currents up to 100 mA, with a supply voltage up to 350 V. The LH1056 is packaged in a six pin 0.3 inch dual-in line package. This package offers an insulation dielectric withstand of 7500 VACPK.

The LH1056 consists of a AlGaAs LED that is optically coupled to a dielectrically isolated photodiode array which drives two series connected high voltage MOS transistors. The typical ON-Resistance is 30 at 25 mA and is linear up to 50 mA. The incremental resistance drops to less than 20  beyond 50 mA while reducing internal power dissipation at high load currents. There is built-in current limiting circuitry in the detector chip.