MFG:MAXIM Package Cooled:SOP D/C:07/08+
MFG: MAXIM
Package Cooled: SOP
D/C: 07/08+
Description: The MAX1901/MAX1902/MAX1904 are buck-topology,step-down, switch-mode, power-supply controllers that ge...
The MAX1901/MAX1902/MAX1904 are buck-topology,step-down, switch-mode, power-supply controllers that generate logic-supply voltages in battery-powered systems.These high-performance, dual/triple-output devices include on-board power-up sequencing, power-good signaling with delay, digital soft-start, secondary winding control, low dropout circuitry, internal frequency-compensation networks, and automatic bootstrapping.
Up to 97% efficiency is achieved through synchronous rectification and Maxim's proprietary Idle Mode™ control scheme. Efficiency is greater than 80% over a 1000:1 load-current range, which extends battery life in system suspend or standby mode. Excellent dynamic response corrects output load transients within five clock cycles.Strong 1A on-board gate drivers ensure fast external Nchannel MOSFET switching.
These devices feature a logic-controlled and synchronizable,fixed-frequency, pulse-width modulation (PWM) operating mode. This reduces noise and RF interference in sensitive mobile communications and pen-entry applications.Asserting the SKIP pin enables fixed-frequency mode, for lowest noise under all load conditions.
The MAX1901/MAX1902/MAX1904 include two PWM regulators, adjustable from 2.5V to 5.5V with fixed 5.0V and 3.3V modes. All these devices include secondary feedback regulation, and the MAX1902 contains a 12V/120mA linear regulator. The MAX1901/MAX1904 include a secondary feedback input (SECFB), plus a control pin (STEER) that selects which PWM (3.3V or 5V) receives the secondary feedback signal. SECFB provides a method for adjusting the secondary winding voltage regulation point with an external resistor divider, and is intended to aid in creating auxiliary voltages other than fixed 12V.
The MAX1901/MAX1902 contain internal output overvoltage and undervoltage protection features.
V+ to GND ...........................................................-0.3V to +36V
PGND to GND...................................................................±0.3V
VL to GND .............................................................-0.3V to +6V
BST3, BST5 to GND ..............................................-0.3V to +36V
CSH3, CSH5 to GND...............................................-0.3V to +6V
FB3 to GND.............................................-0.3V to (CSL3 + 0.3V)
FB5 to GND..............................................-0.3V to (CSL5 +0.3V)
LX3 to BST3...........................................................-6V to +0.3V
LX5 to BST5...........................................................-6V to +0.3V
REF, SYNC, SEQ, STEER, SKIP,
TIME/ON5, SECFB, RESET to GND .........-0.3V to (VL + 0.3V)
VDD to GND..........................................................-0.3V to +20V
RUN/ON3, SHDN to GND.............................-0.3V to (V+ + 0.3V)
12OUT to GND .........................................-0.3V to (VDD + 0.3V)
DL3, DL5 to PGND.......................................-0.3V to (VL + 0.3V)
DH3 to LX3 ............................................-0.3V to (BST3 + 0.3V)
DH5 to LX5 ............................................-0.3V to (BST5 + 0.3V)
VL, REF Short to GND ..............................................Momentary
12OUT Short to GND...............................................Continuous
REF Current........................................................+5mA to -1mA
VL Current......................................................................+50mA
12OUT Current . ...........................................................+200mA
VDD Shunt Current..........................................................+15mA
Continuous Power Dissipation (TA = +70°C)
28-Pin SSOP (derate 9.52mW/°C above +70°C) .........762mW
32-Pin Thin QFN (derate 21.3mW/°C above +70°C) ..1702mW
Operating Temperature Range .........................-40°C to +85°C
Storage Temperature Range ..........................-65°C to +160°C
Lead Temperature (soldering, 10s) ................................+300°C
Stresses beyond those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
MAX1902
PDF/DataSheet Download
IC CNTRLR PWR SPLY LN 32-TQFN
IC CNTRLR PWR SPLY LN 32-TQFN
IC CNTRLR PWR SPLY LN 28-SSOP
IC CNTRLR PWR SPLY LN 28-SSOP
The MAX1901/MAX1902/MAX1904 are buck-topology,step-down, switch-mode, power-supply controllers that generate logic-supply voltages in battery-powered systems.These MAX1901/MAX1902/MAX1904high-performance, dual/triple-output devices include on-board power-up ...
IC ADC 12BIT SERIAL LP 16SOIC
Price: 1-100 USD
RECTIFIER MODULE, DIP-5, 800V Repetive Peak Reverse voltage, 1.5 Nm Screw Torque, 2000V Isolation ...
Price: 0.6-0.88 USD
DIP, 32Kx8 bit, low power, CMOS static RAM, battery backup operation, low data retention current, ...
Price: 82-84 USD
XC95216-10HQ208I - XC95216 In-System Programmable CPLD - Xilinx, Inc
Price: 0.075-0.091 USD
NPN T-1 Standard Phototransistor, 3MM, DARK, 4.8 mA, 30V, LTR-4206E
Price: 0.1-2 USD
Hex Inverter, DIP, ±10 mA
Price: 28-32 USD
BLF245 VHF power MOS transistor
Price: 9-12 USD
12-bit, quad voltage output, digital-to-analog converter, PLCC28, –0.3V to +32V, low power
Price: 0.1-1 USD
Si-gate CMOS device, SOP, - 0.5 to +7.0 V
Price: 130-150 USD
silicon N Channel IGBT, intelligent power module, High speed
Price: 0.79-0.95 USD
Insulated Gate Bipolar Transistor, TO-3P, 600V, 15A, 160W, Low saturation voltage
Price: 8-13 USD
Low Cost, Miniature Fiber Optic Component, ZIP, 820 nm Wavelength Technology, Signal Rates up to 1...
Price: 2.9-3 USD
dot matrix LCD driver, QFP, VSS –8.0 ~ +0.3 V, CMOS technology
