Purchase MBM29LV652UE-90/12, In-stock MBM29LV652UE-90/12 From SeekIC.
Part Number: MBM29LV652UE-90/12
Description: The MBM29LV652UE is a 64M-bit, 3.0 V-only Flash memory organized as 4M words of 16 bits each. The devi...
- Table of contents:
MBM29LV652UE-90/12
-
Suppliers
DataSheet
General Description
MBM29LV652UE-90/12 General Description
The MBM29LV652UE is a 64M-bit, 3.0 V-only Flash memory organized as 4M words of 16 bits each. The device is designed to MBM29LV652UEbe programmed in system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase operations. The devices can also be reprogrammed in standard EPROM programmers.
To eliminate bus contention the devices have separate chip enable (CE), write enable (WE), and output enable (OE) controls.
The MBM29LV652UE is entirely command set compatible with JEDEC single-power-supply Flash standard.Commands are written to the command register using standard microprocessor write timings. Register contents serve as input to an internal state-machine which controls the erase and programming circuitry. Write cycles also internally latch addresses and data needed for the programming and erase operations.Typically, each sector can be programmed and verified in about 0.5 seconds.
MBM29LV652UE-90/12 Maximum Ratings
| Parameter |
Symbol | Rating | Unit | |
| Min. | Max. | |||
| Storage Temperature | Tstg | 55 | +125 | |
| Ambient Temperature with Power Applied | TA | 40 | +85 | |
| with Respect to Ground All Pins Except A9, OE, ACC, and RESET (Note 1) |
VIN, VOUT | 0.5 | VCC +0.5 | V |
| Power Supply Voltage (Note 1) |
VCC | 0.5 | +4.0 | V |
| A9, OE, ACC, and RESET (Note 2) |
VIN | 0.5 | +13.0 | V |
| Power Supply Voltage | VCCq | 0.2 | +7.0 | V |
Notes: 1. Minimum DC voltage on input or l/O pins is -0.5 V. During voltage transitions, input or I/O pins may undershoot VSS to -2.0 V for periods of up to 20 ns. Maximum DC voltage on input or l/O pins is VCC +0.5 V. During voltage transitions, input or I/O pins may overshoot to VCC +2.0 V for periods of up to 20 ns.
2. Minimum DC input voltage on A9, OE, ACC, and RESET pins is 0.5 V. During voltage transitions, A9,OE, ACC, and RESET pins may undershoot VSS to -2.0 V for periods of up to 20 ns. Voltage difference between input and supply voltage (VIN-VCC) does not exceed 9.0 V. Maximum DC input voltage on A9,OE, ACC, and RESET pins is +13.0 V which may overshoot to +14.0 V for periods of up to 20 ns.
MBM29LV652UE-90/12 Features
• 0.23 mm Process Technology
• Single 3.0 V read, program and erase
Minimizes system level power requirements
• Compatible with JEDEC-standards
Uses same software commands with single-power supply Flash
• Address don't care during the command sequence
• Industry-standard pinouts
63-ball FBGA (Package suffix: PBT)
• Minimum 100,000 program/erase cycles
• High performance
90 ns maximum access time
• Flexible sector architecture
One hundred twenty-eight 32K word sectors
Any combination of sectors can be concurrently erased. Also supports full chip erase
• Hidden ROM (Hi-ROM) region
128 word of Hi-ROM, accessible through a new "Hi-ROM Enable" command sequence
Factory serialized and protected to provide a secure electronic serial number (ESN)
• Ready/Busy Output (RY/BY)
Hardware method for detection of program or erase cycle completion
• ACC input pin
At VACC, increases program performance
• Embedded EraseTM* Algorithms
Automatically pre-programs and erases the chip or any sector
• Embedded programTM* Algorithms
Automatically writes and verifies data at specified address
• Data Polling and Toggle Bit feature for detection of program or erase cycle completion
• Automatic sleep mode
When addresses remain stable, automatically switches themselves to low power mode
• Low VCC write inhibit 2.5 V
• Erase Suspend/Resume
Suspends the erase operation to allow a read data and/or program in another sector within the same device
• Sector group protection
Hardware method disables any combination of sector groups from program or erase operations
• Sector Group Protection Set function by Extended sector protect command
• Fast Programming Function by Extended Command
• Temporary sector group unprotection
Temporary sector group unprotection via the RESET pin
This feature allows code changes in previously locked sectors
• In accordance with CFI (Common Flash Memory Interface)
*: Embedded EraseTM and Embedded ProgramTM are trademarks of Advanced Micro Devices, Inc.
• Single 3.0 V read, program and erase
Minimizes system level power requirements
• Compatible with JEDEC-standards
Uses same software commands with single-power supply Flash
• Address don't care during the command sequence
• Industry-standard pinouts
63-ball FBGA (Package suffix: PBT)
• Minimum 100,000 program/erase cycles
• High performance
90 ns maximum access time
• Flexible sector architecture
One hundred twenty-eight 32K word sectors
Any combination of sectors can be concurrently erased. Also supports full chip erase
• Hidden ROM (Hi-ROM) region
128 word of Hi-ROM, accessible through a new "Hi-ROM Enable" command sequence
Factory serialized and protected to provide a secure electronic serial number (ESN)
• Ready/Busy Output (RY/BY)
Hardware method for detection of program or erase cycle completion
• ACC input pin
At VACC, increases program performance
• Embedded EraseTM* Algorithms
Automatically pre-programs and erases the chip or any sector
• Embedded programTM* Algorithms
Automatically writes and verifies data at specified address
• Data Polling and Toggle Bit feature for detection of program or erase cycle completion
• Automatic sleep mode
When addresses remain stable, automatically switches themselves to low power mode
• Low VCC write inhibit 2.5 V
• Erase Suspend/Resume
Suspends the erase operation to allow a read data and/or program in another sector within the same device
• Sector group protection
Hardware method disables any combination of sector groups from program or erase operations
• Sector Group Protection Set function by Extended sector protect command
• Fast Programming Function by Extended Command
• Temporary sector group unprotection
Temporary sector group unprotection via the RESET pin
This feature allows code changes in previously locked sectors
• In accordance with CFI (Common Flash Memory Interface)
*: Embedded EraseTM and Embedded ProgramTM are trademarks of Advanced Micro Devices, Inc.
MBM100A6
PDF/DataSheet Download
- Datasheet: MBM100A6
- File Size: 79491 KB
- Manufacturer: HITACHI [Hitachi Semiconductor]
- Click here to Download
- ·MBM100F12
- HITACHI [Hitachi Semiconductor]
- IGBT MODULE RANGE WITH SOFT AND FAST (SFD) FREE-WHEELING DIODES
- 79491 KB
- ·MBM150A6
- HITACHI [Hitachi Semiconductor]
- IGBT MODULE RANGE WITH SOFT AND FAST (SFD) FREE-WHEELING DIODES
- 79491 KB
- ·MBM150F12
- HITACHI [Hitachi Semiconductor]
- IGBT MODULE RANGE WITH SOFT AND FAST (SFD) FREE-WHEELING DIODES
- 79491 KB
- ·MBM200A6
- HITACHI [Hitachi Semiconductor]
- IGBT MODULE RANGE WITH SOFT AND FAST (SFD) FREE-WHEELING DIODES
- 79491 KB
- ·MBM2212-20
- FUJITSU [Fujitsu Media Devices Limited]
- MOS 1024 BIT NON VOLATILE RANDOM ACCESS MEMORY
- 373835 KB
- ·MBM2212-25
- FUJITSU [Fujitsu Media Devices Limited]
- MOS 1024 BIT NON VOLATILE RANDOM ACCESS MEMORY
- 373835 KB
- ·MBM2732-45
- Fujitsu
- 470965 KB
- ·MBM2764
- FUJITSU [Fujitsu Media Devices Limited]
- UV ERASABLE 65536-BIT READ ONLY MEMORY
- 589903 KB
MBM29LV652UE-90/12 Relative Products
MBM29LV652UE90
The MBM29LV652UE90 is a 64M-bit, 3.0 V-only Flash memory organized as 4M words of 16 bits each. The device is designed to MBM29LV652UE be programmed in system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or e...
MBM29LV652UE -90
The MBM29LV652UE -90 is entirely command set compatible with JEDEC single-power-supply Flash standard.Commands are written to the command register using standard microprocessor write timings. Register contents serve as input to an internal state-machine whic...
MBM29LV652UE -12
The MBM29LV652UE -12 is entirely command set compatible with JEDEC single-power-supply Flash standard.Commands are written to the command register using standard microprocessor write timings. Register contents serve as input to an internal state-machine whic...
MBM29LV651UE-90/12
The MBM29LV651UE-90/12 is a 64M-bit, 3.0 V-only Flash memory organized as 4M words of 16 bits each. The device is designed to be programmed in system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase oper...
MBM29LV651UE-90
The MBM29LV651UE-90 is a 64M-bit, 3.0 V-only Flash memory organized as 4M words of 16 bits each. The device is designed to be programmed in system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase operati...
MBM29LV651UE90
The MBM29LV651UE90 is a 64M-bit, 3.0 V-only Flash memory organized as 4M words of 16 bits each. The device is designed to be programmed in system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase operatio...
Hotspot Suppliers Product
10937P-50
Price: 1.9-2.4 USD
Alphanumeric Display Controller, DIP, +0.3 to -20 V, MOS/LSI, 7 mA
XC5VSX240T-1FF1738I
Price: 6980-7500 USD
FPGA, 1738-FCBGA, –0.75 to 4.05 V, ±100 mA, XC5VSX240T-1FF1738I, Xilinx, Inc
XC95216-10PQ160I
Price: 54-56 USD
IC CPLD 216 MCELL I-TEMP 160PQFP - XC95216-10PQ160I
5962-7802301MEA
Price: 5.7-6.5 USD
line driver, dip, complementary-output, 7 V, Complementary Outputs, TTL Compatible
STP11NM80
Price: 1-2 USD
Power MOSFET, 800V, 11A, TO-220, 150W, STP11NM80
CM75DY-24NF
Price: 75-150 USD
CM75DY-24NF IGBT module 75 Amperes/1200 Volts
ATMEGA32A-AU
Price: 2.5-3.9 USD
MCU AVR 32K FLASH 16MHZ 44-TQFP - ATMEGA32A-AU
AP1501-50
Price: 0.47-0.94 USD
3A PWM buck DC/DC converter, TO-263, +45 V, -0.3 to +40 V, Low power standby mode, RoHS Compliant
TDA9874APS
Price: 4.69-6.25 USD
Digital TV, sound demodulator/decoder, DIP42, Sound IF input switch, Switchable 10 dB, SIF input a...
ST7010T-R
Price: 1-1.5 USD
Audio & Signal, laminated transformer, SOP16, surface mout, 10V C.T, 3.6A
MAX1473EUI+T
Price: 1.5-1.6 USD
TSSOP-28, 10.7MHz, 2.5μA, Low-Current Power-Down, 114dBm, 5.2mA, 6.0V
CM200HA-24H
Price: 1-1 USD
IGBT Module, 1200V, 200 Ampere
