Purchase MC9S12DJ512, In-stock MC9S12DJ512 From SeekIC.
Part Number: MC9S12DJ512
Description: This section describes signals that connect off-chip. It includes a pinout diagram, a table of signal properties, and d...
- Table of contents:
MC9S12DJ512
-
Suppliers
DataSheet
General Description
MC9S12DJ512 General Description
This section describes signals that connect off-chip. It includes a pinout diagram, a table of signal properties, and detailed discussion of signals. It is built from the signal description sections of the Block Guides of the individual IP blocks on the device.
MC9S12DJ512 Maximum Ratings
Absolute maximum ratings are stress ratings only. A functional operation under or outside those maxima is not guaranteed. Stress beyond those limits may affect the reliability or cause permanent damage of the device.
This device contains circuitry protecting against damage due to high static voltage or electrical fields; however, it is advised that normal precautions be taken to avoid application of any voltages higher than maximum-rated voltages to this high-impedance circuit. Reliability of operation is enhanced if unused inputs are tied to an appropriate logic voltage level (e.g., either VSS5 or VDD5).
Num
Rating
Symbol
Min
Max
Unit
1
I/O, Regulator and Analog Supply Voltage
VDD5
-0.3
6.0
V
2
Digital Logic Supply Voltage 2
VDD
-0.3
3.0
V
3
PLL Supply Voltage 2
VDDPLL
-0.3
3.0
V
4
Voltage difference VDDX to VDDR and VDDA
DVDDX
-0.3
0.3
V
5
Voltage difference VSSX to VSSR and VSSA
DVSSX
-0.3
0.3
V
6
Digital I/O Input Voltage
VIN
-0.3
6.0
V
7
Analog Reference
VRH, VRL
-0.3
6.0
V
8
XFC, EXTAL, XTAL inputs
VILV
-0.3
3.0
V
9
TEST input
VTEST
-0.3
10.0
V
10
Instantaneous Maximum Current
Single pin limit for all digital I/O pins 3ID
-25
+25
mA
11
Instantaneous Maximum Current
Single pin limit for XFC, EXTAL, XTAL4IDL
-25
+25
mA
12
Instantaneous Maximum Current
Single pin limit for TEST 5IDT
-0.25
0
mA
13
Storage Temperature Range
Tstg
65
155
MC9S12DJ512 Features
• HCS12 Core
16-bit HCS12 CPU
i. Upward compatible with M68HC11 instruction set
ii. Interrupt stacking and programmer's model identical to M68HC11
iii. Instruction queue
iv. Enhanced indexed addressing
MEBI (Multiplexed External Bus Interface)
MMC (Module Mapping Control)
INT (Interrupt control)
BKP (Breakpoints)
BDM (Background Debug Mode)
• CRG (Clock and Reset Generation)
Low current Colpitts oscillator or
Pierce oscillator
PLL
COP watchdog
Real Time Interrupt
Clock Monitor
• 8-bit and 4-bit ports with interrupt functionality
Digital filtering
Programmable rising or falling edge trigger
• Memory
512K Flash EEPROM
4K byte EEPROM
14K byte RAM
• Two 8-channel Analog-to-Digital Converters
10-bit resolution
External conversion trigger capability
• Five 1M bit per second, CAN 2.0 A, B software compatible modules
Five receive and three transmit buffers
Flexible identifier filter programmable as 2 x 32 bit, 4 x 16 bit or 8 x 8 bit
Four separate interrupt channels for Rx, Tx, error and wake-up
Low-pass filter wake-up function
Loop-back for self test operation
• Enhanced Capture Timer
16-bit main counter with 7-bit prescaler
8 programmable input capture or output compare channels
Four 8-bit or two 16-bit pulse accumulators
• 8 PWM channels
Programmable period and duty cycle
8-bit 8-channel or 16-bit 4-channel
Separate control for each pulse width and duty cycle
Center-aligned or left-aligned outputs
Programmable clock select logic with a wide range of frequencies
Fast emergency shutdown input
Usable as interrupt inputs
• Serial interfaces
Two asynchronous Serial Communications Interfaces (SCI)
Three Synchronous Serial Peripheral Interface (SPI)
• Byte Data Link Controller (BDLC)
SAE J1850 Class B Data Communications Network Interface Compatible and ISO Compatible for Low-Speed (<125 Kbps) Serial Data Communications in Automotive Applications
• Inter-IC Bus (IIC)
Compatible with I2C Bus standard
Multi-master operation
Software programmable for one of 256 different serial clock frequencies
• 112-Pin LQFP package
I/O lines with 5V input and drive capability
5V A/D converter inputs
Operation at 50MHz equivalent to 25MHz Bus Speed over -40 <= TA <= 125
Development support
Single-wire background debug™ mode (BDM)
On-chip hardware breakpoints
16-bit HCS12 CPU
i. Upward compatible with M68HC11 instruction set
ii. Interrupt stacking and programmer's model identical to M68HC11
iii. Instruction queue
iv. Enhanced indexed addressing
MEBI (Multiplexed External Bus Interface)
MMC (Module Mapping Control)
INT (Interrupt control)
BKP (Breakpoints)
BDM (Background Debug Mode)
• CRG (Clock and Reset Generation)
Low current Colpitts oscillator or
Pierce oscillator
PLL
COP watchdog
Real Time Interrupt
Clock Monitor
• 8-bit and 4-bit ports with interrupt functionality
Digital filtering
Programmable rising or falling edge trigger
• Memory
512K Flash EEPROM
4K byte EEPROM
14K byte RAM
• Two 8-channel Analog-to-Digital Converters
10-bit resolution
External conversion trigger capability
• Five 1M bit per second, CAN 2.0 A, B software compatible modules
Five receive and three transmit buffers
Flexible identifier filter programmable as 2 x 32 bit, 4 x 16 bit or 8 x 8 bit
Four separate interrupt channels for Rx, Tx, error and wake-up
Low-pass filter wake-up function
Loop-back for self test operation
• Enhanced Capture Timer
16-bit main counter with 7-bit prescaler
8 programmable input capture or output compare channels
Four 8-bit or two 16-bit pulse accumulators
• 8 PWM channels
Programmable period and duty cycle
8-bit 8-channel or 16-bit 4-channel
Separate control for each pulse width and duty cycle
Center-aligned or left-aligned outputs
Programmable clock select logic with a wide range of frequencies
Fast emergency shutdown input
Usable as interrupt inputs
• Serial interfaces
Two asynchronous Serial Communications Interfaces (SCI)
Three Synchronous Serial Peripheral Interface (SPI)
• Byte Data Link Controller (BDLC)
SAE J1850 Class B Data Communications Network Interface Compatible and ISO Compatible for Low-Speed (<125 Kbps) Serial Data Communications in Automotive Applications
• Inter-IC Bus (IIC)
Compatible with I2C Bus standard
Multi-master operation
Software programmable for one of 256 different serial clock frequencies
• 112-Pin LQFP package
I/O lines with 5V input and drive capability
5V A/D converter inputs
Operation at 50MHz equivalent to 25MHz Bus Speed over -40 <= TA <= 125
Development support
Single-wire background debug™ mode (BDM)
On-chip hardware breakpoints
MC9S12DJ512 Connection Diagram
MC9S12DJ512
PDF/DataSheet Download
- Datasheet: MC9S12DJ512
- File Size: 2176759 KB
- Manufacturer: FREESCALE [Freescale Semiconductor, Inc]
- Click here to Download
- ·MC908AP16ACB
- FREESCALE [Freescale Semiconductor, Inc]
- Microcontrollers
- 1484309 KB
- ·MC908AP16ACFA
- FREESCALE [Freescale Semiconductor, Inc]
- Microcontrollers
- 1484309 KB
- ·MC908GR16ACFA
- FREESCALE [Freescale Semiconductor, Inc]
- M68HC08 Microcontrollers
- 1930870 KB
- ·MC908GR4CDWR2
- MOTOROLA [Motorola, Inc]
- Microcontrollers
- 3179232 KB
- ·MC908GR4CFAR2
- MOTOROLA [Motorola, Inc]
- Microcontrollers
- 3179232 KB
- ·MC908GR4MDWR2
- MOTOROLA [Motorola, Inc]
- Microcontrollers
- 3179232 KB
- ·MC908GR4MFAR2
- MOTOROLA [Motorola, Inc]
- Microcontrollers
- 3179232 KB
- ·MC908GR4VDWR2
- MOTOROLA [Motorola, Inc]
- Microcontrollers
- 3225931 KB
MC9S12DJ512 Relative Products
MC9S12DJ256VPVE
IC MCU 16BIT 256K FLASH 112-LQFP
MC9S12DJ256MPVE
IC MCU 256K FLASH 25MHZ 112-LQFP
MC9S12DJ256MFUE
IC MCU 256K FLASH 25MHZ 80-QFP
MC9S12DJ256CPVE
IC MCU 256K FLASH 4K EE 112-LQFP
MC9S12DJ256CFUE
The MC9S12DJ256CFUE is one member of the MC9S12DJ256 family which designed as the 16-bit device composed of standard on-chip peripherals including a 16-bit central processing unit (HCS12 CPU), 256K bytes of Flash EEPROM, 12K bytes of RAM, 4K bytes of EEPROM,...
MC9S12DJ256CCPV
IC MCU 256K FLASH 25MHZ 112-LQFP
Hotspot Suppliers Product
JAN1N3326B
Price: 10-15 USD
Microsemi JAN1N3326B, 2DO-5, Single, 36 V, Voltage Regulator
C8051F120-GQR
Price: 5.99-8.89 USD
System-on-a-Chip MCU, 100TQFP, 100MHz, 8-Bit, 3 V ~ 3.6 V
D2532ES
Price: 30-35 USD
D2532ES, Optical Inspection Equipment, Agere Systems
A02TJ
Price: 0.132-0.137 USD
air core spring inductor, SMD, 5.0nH, 6.5GHz, 4A, coilcraft
AT25640AN-10SU-2.7
Price: 0.5-2 USD
SPI Serial EEPROM, 5.0 MHz Clock Rate, 32-byte Page Mode, Block Write Protection, SOP8
PL-2303HXDLF
Price: 1-1.2 USD
USB to RS-232 Bridge Controller, 28 Pins SOIC package, -0.3 to 6.0 V
AN2131SC
Price: 8-10 USD
IC MCU 8051 8K RAM 24MHZ 44QFP - AN2131SC
AT90CAN32-16AU
Price: 4.9-5 USD
CMOS 8-bit microcontroller, 64-lead TQFP, 64-lead QFN, 32K Bytes of ISP Flash, CAN Controller
PS21245-E
Price: 0.1-0.2 USD
PS21245-E, MITSUBISHI Electronics, 450V, 20A, 56W, IGBT inverter bridge
EPM7064AETC44-4N
Price: 1.5-2 USD
Programmable Logic Device, QFP, –0.5~4.6 V
K4J55323QG-BC14
Price: 2.25-2.35 USD
256M, 2M x 32Bit x 4 Banks, 700MHz, GDDR3 SDRAM
TMS320C6201GJC200
Price: 1-100 USD
DSP, BGA, -0.3 V to 3 V, very-long-instruction-word architecture
