MDT2030

The followings are some of the features on the hardware and software :
`Fully CMOS static design
`8-bit data bus
`On chip EPROM size : 2.0 K words
`Internal RAM size : 80 bytes (73 general purpose registers, 7 special registers)
`36 single word instructions
`14-bit instructions
`2-level stacks
`Operating voltage : 2.3 V ~ 5.5 V
`Operating frequency : 0 ~ 20 MHz
`The most fast execution time is 200 ns under 20 MHz in all single cycle instructions except the branch instruction
`Addressing modes include direct, indirect and relative addressing modes
`Power-on Reset
`Power edge-detector Reset
`Sleep Mode for power saving
`4 types of oscillator can be selected by programming option: RC-Low cost RC oscillator LFXT-Low frequency crystal oscillator XTAL-Standard crystal oscillator HFXT-High frequency crystal oscillator
`4 oscillator start-up time can be selected by programming option: 150 ms, 20 ms, 40 ms, 80 ms
`8-bit real time clock/counter(RTCC) with 8-bit programmable prescaler
`On-chip RC oscillator based Watchdog Timer(WDT)
`12 I/O pins with their own independent direction control

The application areas of this MDT2030 range from appliance motor control and high speed automotive to low power remote transmitters/receivers, pointing devices, and telecommunications processors, such as Remote controller, small instruments, chargers, toy, automobile and PC peripheral . etc.

This MDT2030 ROM-Based 8-bit micro-controller uses a fully static CMOS technology process to achieve high speed, small size, the low power and high noise immunity. On chip memory includes 2K words EPROM, and 80 bytes static RAM.