Purchase MMC2114, In-stock MMC2114 From SeekIC.
Part Number: MMC2114
Description: ` Phase-lock loop (PLL): Reference crystal from 2 to 10 MHz ...
- Table of contents:
MMC2114
-
Suppliers
DataSheet
General Description
MMC2114 General Description
` Phase-lock loop (PLL):
Reference crystal from 2 to 10 MHz
Low-power modes supported
Separate clock-out signal
` Integrated low-voltage detector (LVD):
Can be enabled and disabled under software control
Sets flag when VDD drops below internal bandgap reference threshold
Reset and interrupt request enable bits
Optional automatic disabling in low-power stop mode
` Reset:
Separate reset in and reset out signals
Seven sources of reset:
Power-on reset (POR)
External
Software
Watchdog timer
Loss of clock
Loss of PLL lock
Low-voltage detect
Status flag indicates source of last reset
` Chip configurations:
Support for single-chip, master, emulation, and test modes
System configuration during reset
Bus monitor
Configurable output pad drive strength control
` General-purpose input/output (GPIO):
Up to 72 bits of GPIO
Coherent 32-bit control
Bit manipulation supported via set/clear functions
Unused peripheral pins may be used as extra GPIO.
MMC2114 Maximum Ratings
|
Parameter |
Symbol |
Value |
Unit |
| Supply voltage |
VDD |
0.3 to +4.0 |
V |
| Clock synthesizer supply voltage |
VDDSYN |
0.3 to +4.0 |
V |
| RAM memory standby supply voltage |
VSTBY |
0.3 to +4.0 |
V |
| FLASH memory supply voltage |
VDDF |
0.3 to +4.0 |
V |
| FLASH memory program/erase supply voltage |
VPP |
0.3 to + 6.0 |
V |
| Analog supply voltage |
VDDA |
0.3 to + 6.0 |
V |
| Analog reference supply voltage |
VRH |
0.3 to + 6.0 |
V |
| Analog ESD protection voltage |
VDDH |
0.3 to + 6.0 |
V |
| Digital input voltage(1) |
VIN |
0.3 to + 4.0 |
V |
| Analog input voltage |
VAIN |
0.3 to + 6.0 |
V |
| Instantaneous maximum current single pin limit (applies to all pins)(2), (3) |
ID |
25 |
mA |
| Operating temperature range (packaged) |
TA |
40 to 85 |
|
| Storage temperature range |
TSTG |
65 to 150 |
` Input must be current limited to the value specified. To determine the value of the required current-limiting resistor, calculate resistance values for positive and negative clamp voltages, then use the larger of the two values.
` All functional non-supply pins are internally clamped to VSS and VDD.
` Power supply must maintain regulation within operating VDD range during instantaneous and operating maximum current conditions. If positive injection current (Vin > VDD) is greater than IDD, the injection current may flow out of VDD and could result in external power supply going out of regulation. Ensure external VDD load will shunt current greater than maximum injection current. This will be the greatest risk when the MCU is not consuming power (ex; no clock). Power supply must maintain regulation within operating VDD range during instantaneous and operating maximum current conditions.
MMC2114
PDF/DataSheet Download
- Datasheet: MMC2114
- File Size: 8263041 KB
- Manufacturer: MOTOROLA [Motorola, Inc]
- Click here to Download
- ·MMC16M
- 15 AMPERES RMS 400 thru 800 VOLTS
- 137831 KB
- ·MMC2001
- Motorola
- MMC2001 M?CORE ? Integrated Microcontroller
- 98694 KB
- ·MMC2075
- MOTOROLA [Motorola, Inc]
- Integrated Processor with Roaming FLEX Decoder
- 49152 KB
- ·MMC2075VF001
- MOTOROLA [Motorola, Inc]
- Integrated Processor with Roaming FLEX Decoder
- 787237 KB
- ·MMC2080
- MOTOROLA [Motorola, Inc]
- Integrated Processor with Roaming FLEX Decoder
- 787237 KB
- ·MMC2080VF001
- MOTOROLA [Motorola, Inc]
- Integrated Processor with Roaming FLEX Decoder
- 787237 KB
- ·MMC2107
- MOTOROLA [Motorola, Inc]
- HCMOS Microcontroller Unit
- 7550298 KB
- ·MMC2107PU
- MOTOROLA [Motorola, Inc]
- HCMOS Microcontroller Unit
- 7550298 KB
MMC2114 Relative Products
MMC2113CFCVF33
IC MCU 128K FLASH 33MHZ 196-BGA
MMC2113CFCPV33
IC MCU 128K FLASH 33MHZ 144-LQFP
MMC2113CFCPU33
IC MCU 128K FLASH 33MHZ 100-LQFP
MMC2113
` MMC2113 Phase-lock loop (PLL): Reference crystal from 2 to 10 MHz Low-power modes supported Separate clock-out signal` MMC2113 Integrated low-voltage detector (LVD): Can be enabled and disabled under software control Sets flag when VDD drops below int...
MMC2112
` Phase-lock loop (PLL) of MMC2112: Reference crystal from 2 to 10 MHz Low-power modes supported Separate clock-out signal` Integrated low-voltage detector (LVD) of MMC2112: Can be enabled and disabled under software control Sets flag when VDD drops bel...
MMC2107CFCPV33
IC MCU 33MHZ 128K FLASH 144-LQFP
Hotspot Suppliers Product
MT28F008B3VG-9B
Price: 1-1.5 USD
programmable memory, 40-Pin TSOP, -0.5V to +5.5V, 1W, Smart 3 technology
AT90USB162-16AU
Price: 1-5 USD
CMOS 8-bit microcontroller, 32-TQFP, 16MHz, 2.7 V ~ 5.5 V, AT90USB162-16AU
TL7702AID
Price: 0.155-0.16 USD
supply-voltage supervisor, 8-SOIC, 20V, Power-On Reset Generator, 30mA
AT89S52-24AU
Price: 0.95-1.2 USD
IC MCU 8K FLASH 24MHZ 44-TQFP - AT89S52-24AU
UPD70320L-8
Price: 8.4-8.5 USD
single-chip microcontroller, PLCC84, 16/8-BIT
IDT7132LA35CB
Price: 40-55 USD
high-speed, 2K x 8 Dual-Port Static RAM, DIP48, -0.5 to +7.0V, High-speed access
F0805B0R75FWTR
Price: 0.1-0.5 USD
SMD thin-film fuse, 0.75A, 63V, SOP, Accurate current rating, 107%
D450AA01+008
Price: 1-2 USD
D450AA01+008, QFP, Integrated Circuits, 3M Electronics
CY8C20110
Price: 0.9-1.3 USD
CapSenseLITE controller, 16UQFN, 2.4V to 5.25V, 1mA, CY8C20110
LC4032V-75T48C
Price: 1-1.5 USD
SuperFAST High Density PLD, 3.3V/2.5V/1.8V, QFP, 400MHz, 2.5ns, LC4032V-75T48C
ADG-296C
Price: 8-9 USD
ADG-296C, PLCC, Analog Devices
G6M-1A-DC12V
Price: 1.15-1.8 USD
PCB Power Relay, Slim 5-mm width, RoHS Compliant, 10 ms Operate time, 5 ms Release time, 100 mΩ Co...
