RF1046

Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified
   demonstration board with impedance matching to 50 W and measured with 50 W network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent
   on PCB layout and external impedance matching design. See Application Note No. 42 for details. All "NC" or "no connection"
   terminals should be grounded.
4. "LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may
   vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
9. ãCopyright 1999, RF Monolithics Inc.
10. Electrostatic Sensitive Device. Observe precautions for handling.