SAB80C166W

` High Performance 16-bit CPU with 4-Stage Pipeline
` 100 ns Instruction Cycle Time at 20 MHz CPU Clock
` 500 ns Multiplication (16 * 16 bits), 1 s Division (32 / 16 bit)
` Enhanced Boolean Bit Manipulation Facilities
` Register-Based Design with Multiple Variable Register Banks
` Single-Cycle Context Switching Support
` Up to 256 KBytes Linear Address Space for Code and Data
` 1 KByte On-Chip RAM
` 32 KBytes On-Chip ROM (SAB 83C166W only)
` Programmable External Bus Characteristics for Different Address Ranges
` 8-Bit or 16-Bit External Data Bus
` Multiplexed or Demultiplexed External Address/Data Buses
` Hold and Hold-Acknowledge Bus Arbitration Support
` 512 Bytes On-Chip Special Function Register Area
` Idle and Power Down Modes
` 8-Channel Interrupt-Driven Single-Cycle Data Transfer Facilities via Peripheral Event Controller (PEC)
` 16-Priority-Level Interrupt System
` 10-Channel 10-bit A/D Converter with 9.7 ms Conversion Time
` 16-Channel Capture/Compare Unit
` Two Multi-Functional General Purpose Timer Units with 5 Timers
` Two Serial Channels (USARTs)
` Programmable Watchdog Timer
` Up to 76 General Purpose I/O Lines
` Direct clock input without prescaler
` Supported by a Wealth of Development Tools like C-Compilers, Macro-Assembler Packages,Emulators, Evaluation Boards, HLL-Debuggers, Simulators, Logic Analyzer Disassemblers,Programming Boards
` On-Chip Bootstrap Loader
` 100-Pin Plastic MQFP Package (EIAJ)

Ambient temperature under bias (T_A):
SAB 83C166W-5M, SAB 80C166W-M .................................... 0 to + 70 °C
SAB 83C166W-5M-T3, SAB 80C166W-M-T3 .................... 40 to + 85 °C
SAB 83C166W-5M-T4, SAB 80C166W-M-T4 ................... 40 to + 110 °C
Storage temperature (T_stg) .......................................... 65 to + 150 °C
Voltage on V_CC pins with respect to ground (V_SS) .......... 0.5 to + 6.5 V
Voltage on any pin with respect to ground (V_SS) ...... 0.5 to V_CC + 0.5 V
Input current on any pin during overload condition........ 10 to + 10 mA
Absolute sum of all input currents during overload condition...... |100 mA|
Power dissipation............................................................................... 1 W
Note: Stresses above those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. During overload conditions (V_IN > V_CC or V_IN < V_SS) the voltage on pins with respect to ground (V_SS) must not exceed the values defined by the Absolute Maximum Ratings.