Features: 300kHz to 1MHz externally programmable frequency operation Soft Start and Enable function Power Good output provided Under voltage short circuit protection Phase-shifted switchers minimize ripple High efficiency operation, >90% Programmable output(s) as low as 0.5V Industrial temperat...
SC2677: Features: 300kHz to 1MHz externally programmable frequency operation Soft Start and Enable function Power Good output provided Under voltage short circuit protection Phase-shifted switchers minimize...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Graphics cards
Peripheral add-in card
Dual-Phase power supply
Power supplies requiring two outputs

| Parameter | Symbol | Limits | Units |
| VCC to GND | VIN | -0.3 to 15 | V |
| PGND to GND | ± 1 | V | |
| BST1, BST2 to GND | -0.3 to 20 | V | |
| BSTC to GND | -0.3 to 20 | V | |
| -IN1, +/-IN2 to GND | 7 | V | |
| COMP1, COMP2 to GND | 7 | V | |
| DH1, DH2 to GND | -0.3 to 20 | V | |
| DL1, DL2 to GND | -0.3 to BSTC + 0.3 | V | |
| -3 peak (50nS) (1) | V | ||
| PWRGD to GND | VCC + 0.3 | V | |
| PHASING | 7 | V | |
| SS/ENA to GND | -0.3 to 7 | V | |
| Thermal Resistance Junction to Case | JC | 17 | °C/W |
| Thermal Resistance Junction to Ambient | JA | 90 | °C/W |
| Operating Ambient Temperature Range | TA | 0 to 70 | °C |
| Operating Junction Temperature Range | TJ | 0 to 125 | °C |
| Storage Temperature Range | TSTG | -65 to +150 | °C |
| Lead Temperature (Soldering) 10 sec | TLEAD | 300 | °C |
The SC2677 is a versatile 2 phase, synchronous, voltage mode PWM controller that may be used in two distinct ways. First, the SC2677 is ideal for applications where point of use output power exceeds any single input power budget. Alternatively, the SC2677 can be used as a dual switcher. The SC2677 features a temperature compensated voltage reference, an under voltage lockout over current protection and internal level-shifted, highside drive circuitry.
In current sharing configuration, the SC2677 can produce a single output voltage from two separate voltage sources (which can be different voltage levels) while maintaining current sharing between the channels. Current sharing is programmable to allow loading each input supply as required by the application.
In dual switcher configuration, two feedback paths are provided for independent control of the separate outputs.The device will provide a regulated output from flexibly configured inputs (3.3V, 5V, 12V), provided 5V is present for VCC.The phasing between the two switchers is adjustable to minimize the input and output ripple.