Features: • Clamping Voltage . . . . . . . . . . . . . . . . . . . . .230V or 270V• Rated for Peak Transient Surge Current• High Minimum Holding Current• Low On-State Voltage• UL Recognized File #E135010 to STD 497BApplication• Secondary Protectors for: - Teleph...
SGT27B27: Features: • Clamping Voltage . . . . . . . . . . . . . . . . . . . . .230V or 270V• Rated for Peak Transient Surge Current• High Minimum Holding Current• Low On-State Voltage...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
| Continuous Off State Voltage: |
SGT23B13 |
SGT27B13 |
SGT27B27 |
UNITS |
| VDM .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
200 |
235 |
235 |
V |
| VRM. . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . |
200 |
235 |
235 |
V |
| Transient Peak Surge Current . . . . . . . . . . . . . . . ITSM | ||||
| 1µs x 2µs (Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
300 |
300 |
600 |
A |
| 8µs x 20µs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
200 |
200 |
400 |
A |
| 10µs x 560µs .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
125 |
125 |
250 |
A |
| 10µs x 1000µs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
100 |
100 |
200 |
A |
| One Half Cycle . . . . . . . . . . . .50Hz to 60Hz (Note 2) |
60 |
60 |
60 |
A |
| One Second . . . . . . . . . . . . .50Hz to 60Hz, Halfwave |
30 |
30 |
30 |
A |
| Operating Temperature (TA) . . . . . . . . . . . . . . . . . . . |
-40 to 85 |
-40 to 85 |
-40 to 85 |
|
| Storage Temperature Range (TSTG) . . . . . . . . . . . . . |
-40 to 150 |
-40 to 150 |
-40 to 150 |
NOTES:
1. Unit designed not to fail open below: 900A.
2. One every 30s maximum.
CAUTION: Stresses above those listed in "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress only rating and peration of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.