SN74AHCT1G125

Supply voltage range, V_CC . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 V to 7 V
Input voltage range, V_I (see Note 1) . . . . . . . . . . . . . . . . . . . 0.5 V to 7 V
Output voltage range, V_O (see Note 1) . . . . . . . . . . . 0.5 V to V_CC + 0.5 V
Input clamp current, I_IK (V_I < 0) . . . . . . . . . . . . . . . . . . . . . .. . . . . . 20 mA
Output clamp current, I_OK (V_O < 0 or V_O > V_CC) . . . . . . . . . . . . . . . ±20 mA
Continuous output current, I_O (V_O = 0 to V_CC) . . . . . . . .. . . . . . . . . ±25 mA
Continuous current through V_CC or GND . . . . . . . . . . . . . . . . .. . . . . ±50 mA
Package thermal impedance, JA (see Note 2): DBV package . . . . 347°C/W
                                                                          DCK package . .. . . 389°C/W
Storage temperature range, T_stg . . . . . . . . . . . . . . . . . . . 65°C to 150°C

Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. The input and output voltage ratings may be exceeded if the input and output current ratings are bserved.
2. The package thermal impedance is calculated in accordance with JESD 51.

The SN74AHCT1G125 is a single bus buffer gate/line driver with 3-state output. The output is disabled when the output-enable (OE) input is high. When OE is low, true data is passed from the A input to the Y output.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.The SN74AHCT1G125 is characterized for operation from 40°C to 85°C.