SN74CBT3125CRGYR

Supply voltage range, V_CC ................................................... −0.5 V to 7 V
Control input voltage range, V_IN (see Notes 1 and 2) ...........−0.5 V to 7 V
Switch I/O voltage range, V_I/O (see Notes 1, 2, and 3) ........ −0.5 V to 7 V
Control input clamp current, I_IK (V_IN < 0)...................................... −50 mA
I/O port clamp current, I_I/OK (V_I/O < 0) ........................................ −50 mA
ON-state switch current, I_I/O (see Note 4).................................. ±128 mA
Continuous current through V_CC or GND terminals ..................... ±100 mA
Package thermal impedance, JA (see Note 5): D package ..........86°C/W
                                                    (see Note 5): DB package .........96°C/W
                                                   (see Note 5): DBQ package ........90°C/W
                                                   (see Note 5): DGV package.......127°C/W
                                                   (see Note 5): PW package ........113°C/W
                                                   (see Note 6): RGY package .........47°C/W
Storage temperature range, T_stg ....................................−65°C to 150°C
‡ Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. All voltages are with respect to ground unless otherwise specified.
              2. The input and output voltage ratings may be exceeded if the input and output clamp-current ratings are observed.
              3. V_I and V_O are used to denote specific conditions for V_I/O.
              4. I_I and I_O are used to denote specific conditions for I_I/O.
              5. The package thermal impedance is calculated in accordance with JESD 51-7.
              6. The package thermal impedance is calculated in accordance with JESD 51-5.

The SN74CBT3125CRGYR is a high-speed TTL-compatible FET bus switch with low ON-state resistance (ron),allowing for minimal propagation delay. Active Undershoot-Protection Circuitry on the A and B ports of the SN74CBT3125C provides protection for undershoot up to −2 V by sensing an undershoot event and ensuring that the switch remains in the proper OFF state.

The SN74CBT3125CRGYR is organized as four 1-bit bus switches with separate output-enable (1OE, 2OE, 3OE,4OE) inputs.
It can be used as four 1-bit bus switches or as one 4-bit bus switch. When OE is low, the associated 1-bit bus switch is ON, and the A port is connected to the B port, allowing bidirectional data flow between ports.WhenOEis high, the associated 1-bit bus switch is OFF, and the high-impedance state exists between the A and B ports.

This SN74CBT3125CRGYR is fully specified for partial-power-down applications using Ioff. The Ioff feature ensures that damaging current will not backflow through the device when it is powered down. The device has isolation during power off.