Features: ·Choice of Open-Collector, Open-Emitter, or 3-State Outputs
·High-Impedance Output State for Party-Line Applications
·Single-Ended or Differential AND/NAND Outputs
·Single 5-V Supply
·Dual Channel Operation
·Compatible With TTL
·Short-Circuit Protection
·High-Current Outputs
·Common and Individual Output Controls
·Clamp Diodes at Inputs and Outputs
·Easily Adaptable to SN55114 and SN75114 Applications
·Designed for Use With SN55115 and SN75115Pinout
SpecificationsSupply voltage, VCC (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 V
Input voltage, VI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.5 V
Off-state voltage applied to open-collector outputs . . . . . . . . . . . . . . . . . . . ... . . . . . . 12 V
Continuous total power dissipation (see Note 2) . . . . . . . .. . . See Dissipation Rating Table
Operating free-air temperature range, TA: SN55113 . . . . . . . . . .. . . . . . . . 55 to 125
SN75113 . . . . . . . . . . . . . . . . . . .. . . .. . 0 to 70
Storage temperature range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65 to 150
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds: N package . . . . . 260
Case temperature for 60 seconds: FK package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260
Lead temperature 1,6 mm (1/16 inch) from case for 60 seconds: J or W package . . 300
‡ Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
DescriptionThe SN55113 and SN75113 dual differential line drivers with 3-state outputs are designed to provide all the features of the SN55114 and SN75114 line drivers with the added feature of driver output controls. Individual controls are provided for each output pair, as well as a common control for both output pairs. If any output is low, the associated output is in a high-impedance state and the output can neither drive nor load the bus. This permits many devices to be connected together on the same transmission line for party-line applications.
The output stages are similar to TTL totem-pole outputs, but with the sink outputs, YS and ZS, and the corresponding ctive pullup terminals, YP and ZP, available on adjacent package pins.The SN55113 is characterized for operation over the full military temperature range of 55 to 125. The SN75113 is characterized for operation over the temperature range of 0 to 70.
SN75113 Data Sheet
