TC75S56FU

Features:

• Low-current power supply                        : I_DD = 10 A (typ.)
• Single power supply operation
• Wide common mode input voltage range : V_SS~V_DD − 0.9 V
• Push-pull output circuit
• Low input bias current
• Small package


Pinout




Specifications

Characteristic		Symbol	Rating	Unit
Supply voltage		VDD,VSS	±3.5 or 7	V
Differential input voltage		DVIN	±7	V
Input voltage		VIN	VSS~VDD	V
Output Current		IOUT	±35	mA
Power dissipation	TC75S57F/FU	PD	200	mW
	TC75S57FE		100
Operating temperature		Topr	-40~85
Storage Temperature range		Tstg	-55~125

Note: Using continuously under heavy loads (e.g. theapplication of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e.operating temperature/current/voltage, etc.) are within the absolute maximum ratings.

Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook ("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test report and estimated failure rate,etc).

Note: This device's CMOS structure makes it prone to latch-up. To prevent latch-up, please take the following precautions:

        ` Ensure that no I/O pin's voltage level ever exceeds V_DD or drops below V_SS.
            In addition, check the power-on timing.

        ` Do not subject the device to excessive noise.


Description

The TC75S56F/TC75S56FU/TC75S56FE is a CMOS general-purpose single comparator. The device can operate off a single power supply and draws a lower supply current than a conventional bipolar general-purpose comparator. This device's push-pull output stage can be directly connected to TTL or CMOS logic ICs, among others.