Features: Analog Input Range
TLC5510...2 V Full Scale
TLC5510A...4 V Full Scale
8-Bit Resolution
Integral Linearity Error
±0.75 LSB Max (25°C)
±1 LSB Max (20°C to 75°C)
Differential Linearity Error
±0.5 LSB Max (25°C)
±0.75 LSB Max (20°C to 75°C)
Maximum Conversion Rate
20 Mega-Samples per Second (MSPS) Max
5-V Single-Supply Operation
Low Power Consumption
TLC5510...127.5 mW Typ
TLC5510A...150 mW Typ
(includes reference resistor dissipation)
TLC5510 is Interchangeable With Sony CXD1175ApplicationDigital TV
Medical Imaging
Video Conferencing
High-Speed Data Conversion
QAM DemodulatorsPinout
SpecificationsSupply voltage, VDDA, VDDD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 V
Reference voltage input range, VREFT, VREFB . . . . . . . . . . . . . . . . . . . . . . . . . . . . AGND to VDDA
Analog input voltage range, VI(ANLG). . . . . . . . . . . . . . . . . . . . . . . . . . . ...............AGND to VDDA
Digital input voltage range, VI(DGTL). . . . . . . . . . . . . . . . . . . . . . . . . . ..................DGND to VDDD
Digital output voltage range, VO(DGTL) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. .DGND to VDDD
Operating free-air temperature range, TA. . . . . . . . . . . . . . . . . . . . . . .............20°C to 75°C
Storage temperature range, Tstg. . . . . . . . . . . . . . . . . . . . . . ........................ 55°C to 150°C
DescriptionThe TLC5510 and TLC5510A are CMOS, 8-bit, 20MSPS analog-to-digital converters (ADCs) that utilize a semiflash architecture. The TLC5510 and TLC5510A operate with a single 5-V supply and typically consume only 130 mW of power. Included is an internal sample-and-hold circuit, parallel outputs with high-impedance mode, and internal reference resistors.
The semiflash architecture of TLC5510A reduces power consumption and die size compared to flash converters. By implementing the conversion in a 2-step process, the number of comparators is significantly reduced. The latency of the data output valid is 2.5 clocks.
The TLC5510 uses the three internal reference resistors to create a standard, 2-V, full-scale conversion range using VDDA. Only external jumpers are required to implement this option and eliminates the need for external reference resistors. The TLC5510A uses only the center internal resistor section with an externally applied 4-V reference such that a 4-V input signal can be used. Differential linearity is 0.5 LSB at 25°C and a maximum of 0.75 LSB over the full operating temperature range. Typical dynamic specifications of TLC5510A include a differential gain of 1% and differential phase of 0.7 degrees.
The TLC5510 and TLC5510A are characterized for operation from 20°C to 75°C.
TLC5510A Data Sheet
