Features: · Complete 1.3 GHz single chip system· Low power 5 V, 35 mA· I2C-bus programming· In-lock flag· Varicap drive disable· Low radiation· Address selection for Picture-In-Picture (PIP), DBS tuner (3 addresses)· Analog-to-digital converter· 8 bus controlled ports (6 for TSA5512T), 8 open coll...
TSA5512: Features: · Complete 1.3 GHz single chip system· Low power 5 V, 35 mA· I2C-bus programming· In-lock flag· Varicap drive disable· Low radiation· Address selection for Picture-In-Picture (PIP), DBS tu...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.

| SYMBOL | PARAMETER | CONDITIONS | MIN. | MAX. | UNIT |
| VCC | supply voltage | -0.3 | +6 | V | |
|
Vi(XTAL) |
voltage at pin XTAL | -0.3 | +VCC | V | |
| Vi(SCL) | voltage at pin SCL | -0.3 | +6 | V | |
| VSDA | voltage at pin SDA | -0.3 | +6 | V | |
| Vi(AS) | voltage at pin AS | -0.3 | +Vcc | V | |
| Vo(BS) | voltage at pin BS | -0.3 | +Vcc | V | |
| Vi(RF) | voltage at pins RF1 and RF2 | -0.3 | +Vcc | V | |
| Vo | output voltage at ports P0, P2 and P6 |
-0.3 | +16 | V | |
| output voltage at ports P4, P5 and P7 | |||||
| VPD | output voltage at pin PD | -0.3 | +Vcc | V | |
| VUD | output voltage at pin UD | -0.3 | +Vcc | V | |
| ISDA | output current at pin SDA | open collector | -1 | +Vcc | V |
| Io | output current at pins P0, P1 and P2 |
-1 | +5 | mA | |
| output current at pins P4, P5 and P7 |
emitter follower | -1 | +20 | mA | |
| output current at pin P6 | open collector | -40 | +10 | mA | |
| Tstg | storage temperature | - | +10 | ||
| Tj(max) | maximum junction temperature | - | +150 | ||
| tsc(GND)(max) | maximum short circuit time to GND |
one pin to GND (VCC = 5.5 V;GND = 0 V) | - | 10 | s |
| tsc(VCC)(max) | maximum short circuit time to VCC |
one pin to VCC (VCC = 5.5 V; GND = 0 V) | - | 10 | s |
The TSA5512 is a single chip PLL frequency synthesizer designed for TV tuning systems. Control data is entered via the I2C-bus; five serial bytes are required to address the device, select the oscillator frequency, programme the eight output ports and set the charge-pump current. Four of these ports can also be used as input ports (three general purpose I/O ports, one ADC). Digital information concerning those ports can be read out of the TSA5512 on the SDA line (one status byte) during a READ operation. A flag is set when the loop is "in-lock" and is read during a READ operation. The device has one fixed I2C-bus address and 3 programmable addresses, programmed by applying a specific voltage on Port 3. The phase comparator operates at 7.8125 kHz when a 4 MHz crystal is used.