Features: ` Operation voltage range: 2~5.5V ` Low power dissipation ` Very low ON-resistance: 26 (typ.) at Vcc=3.0V 16 (typ.) at Vcc=4.5V 14 (typ.) at Vcc=5.5V PinoutSpecifications PARAMETER SYMBOL RATINGS UNIT Supply Voltage VCC -0.5~7 V Enable Input Voltage ...
U74AHC1G66: Features: ` Operation voltage range: 2~5.5V ` Low power dissipation ` Very low ON-resistance: 26 (typ.) at Vcc=3.0V 16 (typ.) at Vcc=4.5V 14 (typ.) at Vcc=5.5V PinoutSpecifications PARAMETE...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Features: ` Operation Voltage Range: 2~5.5V` Low Power Dissipation: ICC=1.0A(Max)` High Speed: tpd...
Features: `Operation Voltage Range: 2~5.5V`Low Power Dissipation: ICC=10A(Max)`High Speed: tpd=4.3...
Features: · Operation Voltage Range: 4.5~5.5V· Low Power Dissipation: 10uA(Max)· Inputs are TTL-Vo...
PARAMETER |
SYMBOL |
RATINGS |
UNIT |
Supply Voltage |
VCC |
-0.5~7 |
V |
Enable Input Voltage |
VE |
-0.5~7 |
V |
Enable Input Clamp Current |
IEK |
-20 |
mA |
Switch Diode Current |
ISK |
±20 |
mA |
On-State Switch Current(- 0.5V<Vos<Vcc+0.5V) |
IS |
±25 |
mA |
VCC or GND Current |
ICC |
±75 |
mA |
Power Dissipation |
PD |
250 |
mW |
Storage Temperature |
TSTG |
-65 ~ +150 |
I |
Note 1. The input and output voltage ratings may be exceeded if the input and output current ratings are observed.
2. Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied.
3. To avoid drawing Vcc current out of pin Z, when switch current flows into pin Y, the voltage drop across the bidirectional switch must not exceed 0.4V. If the switch current flows into pin Z, no Vcc current will flow out of pin Y. In this case there is no limit for the voltage drop across the switch, but the voltage at pins Y and Z may not exceed Vcc or GND.
The U74AHC1G66 is an analog switch which transmits signals from pin(Y or Z) to pin (Z or Y) with an active HIGH enable input pin (E). When pin E is LOW, the switch is turned off.