Position: Home > Datasheet list > AD5 Series > Index A > AD53509
Electronica China

Purchase AD53509, In-stock AD53509 From SeekIC.

 

AD53509 Product Image

AD5 Series Datasheet download

Five Points

Part Number: AD53509

 

 

 

 

Description: The AD53509 is a single chip that performs the pin electronics functions of driver, comparator and act...


Urgent Purchase

AD53509 General Description


The AD53509 is a single chip that performs the pin electronics functions of driver, comparator and active load in ATE VLSI and memory testers. In addition, a Schottky diode bridge for the active load and a VCOM buffer are included internally.

The driver is a proprietary design that features three active states: Data High Mode, Data Low Mode and Term Mode as well as an Inhibit State. This facilitates the implementation of high speed active termination. The output voltage range is 2 V to +7 V to accommodate a wide variety of test devices. The output leakage is typically less than 250 nA over the entire signal range.

The dual comparator, with an input range equal to the driver output range, features built-in latches and ECL-compatible outputs. The outputs are capable of driving 50 signal lines terminated to 2 V. Signal tracking capability is upwards of 5 V/ns.

The active load can be set for up to 40 mA load current with less than a 10 A linearity error through the entire set range. IOH, IOL and the buffered VCOM are independently adjustable. On-board Schottky diodes provide high speed switching and low capacitance.

Also included on the chip is an on-board temperature sensor whose purpose is to give an indication of the surface temperature of the DCL. This information can be used to measure JC and JA or flag an alarm if proper cooling is lost. Output from the sensor is a current sink that is proportional to absolute temperature. The gain is trimmed to a nominal value of 1.0 A/K. As an example, the output current can be sensed by using a 10 k resistor connected from 10 V to the THERM (IOUT) pin. A voltage drop across the resistor will be developed that equals: 10K * 1 A/K = 10 mV/K = 2.98 V at room temperature.

AD53509 Maximum Ratings

Power Supply Voltage
VCC to GND . . . . . . . . . . . . . . . . . . . . . . . . .  . . . . . . . . . 13 V
VEE to GND . . . . . . . . . . . . . . . . . . . . . . . . . .  . . . . . . . . 8 V
VCC to VEE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 V
VCCO to GND . . . . . . . . . . . . . . . . . . . .  . . .. . . . . . . . . . 10 V
PWR GND HQ GND . . . . . . . . . . . . . . . . . . .  . . . . . . . . ±0.4 V
Inputs
DATA, DATA, IOD, IOD, RLD, RLD . . . . . . . . .  . . . . +5 V, 2 V
DATA to DATA, IOD to IOD, RLD to RLD . . . . . .  .  . . . . . ±3 V
LEL, LEL, LEH, LEH . . . . . . . . . . . . . . .  . . . . . . . . +5 V, 2 V
LEL to LEL, LEH to LEH . . . . . . . . . . . . . .  . . . .. . . . . . . ±3 V
INHL, INHL . . . . . . . . . . . . . . . . . . . . . . . .  . .  . . . +5 V, 2 V
INHL to INHL . . . . . . . . . . . . . . . . . .  . . . . .. . . . . . . . . . ±3 V
VH, VL, VTERM, VCOM_I to GND . . . . .  . . . .  . . . . +8 V, 3 V
VH to VL . . . . . . . . . . . . . . . . . . . . . . . . .  . . . . . . . . . . ±10 V
(VHVTERM) and (VTERM VL) . . . . . . . . . . . .  . . . . . ±10 V
IOHC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±6 V
IOLC . . . . . . . . . . . . . . . . . . . . . . . . .  . . . . . . . . . . . . . . ±6 V
HCOMP . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . +8 V, 3 V
LCOMP . . . . . . . . . . . . . . . . . . . . . . . .  . .. . . . . . . +8 V, 3 V
HCOMP, LCOMP to VOUT . . . . . . . . . . . . .  . . . . . . . . . ±10 V
Outputs
VOUT Short Circuit Duration . . . . . . . . . . . . . . . . . Indefinite2
VOUT Inhibit Mode . . . . . . . . . . . . . . . . . . .  .. . . . +8 V, 3 V
VHDCPL . . . . . . . . Do Not Connect Except for Cap to VCC
VLDCPL . . . . . . . . Do Not Connect Except for Cap to VEE
QH, QH, QL, QL Maximum IOUT
Continuous . . . . . . . . . . . . . . . . . . . . . . . . . .  . . . . . . . 50 mA
Surge . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 mA
THERM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 V, 0 V
IOHRTN, IOLRTN . . . . . . . . . . . . . . . .  . . . .  . . +8.5 V, 3.5 V
VCOM_S Short Circuit Duration . . . . . . . . . . . . . . . . . . 3 sec2
ORDERING GUIDE
Shipment Method
Package Quantity per Package
Model Description Shipping Container Option
AD53509JSQ 52-Lead LQFP-EDQUAD 90 SQ-52
Environmental
Operating Temperature (Junction) . . . . . . . . . . . . . . . 175°C
Storage Temperature . . . . . . . . . . . . . . . 65°C to +150°C
Lead Temperature (Soldering, 10 sec)3 . . . . . . . . . . . 260°C
NOTES
1Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only; functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Absolute maximum limits apply individually, not in combination. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
2Output short circuit protection is guaranteed as long as proper heat sinking is employed to ensure compliance with the operating temperature limits.
3To ensure lead coplanarity (± 0.002 inches) and solderability, handling with bare hands should be avoided and the device should be stored in environments at 24 °C ± 5°C (75°F ± 10°F) with relative humidity not to exceed 65%.

AD53509 Features

·250 MHz Operation
·Driver/Comparator and Active Load Included
·On-Chip Schottky Diode Bridge
·52-Lead LQFP Package with Built-In Heat Sink

AD53509 Typical Application

·Automatic Test Equipment
·Semiconductor Test Systems
·Board Test Systems
·Instrumentation and Characterization Equipment

AD53509 datasheet

AD53509
PDF/DataSheet Download

Find AD53509 Suppliers

  • ·AD500-9
  • ETC [ETC] 
  • Avalanche Photodiode NIR 
  • 220693 KB
  • AD500-9 Datasheet Download
  • ·AD5011
  • AD [Analog Devices] 
  • 2 Pair/1 Pair ETSI Compatible HDSL Analog Front End 
  • 95527 KB
  • AD5011 Datasheet Download
  • ·AD5011B
  • AD [Analog Devices] 
  • 2 Pair/1 Pair ETSI Compatible HDSL Analog Front End 
  • 95527 KB
  • AD5011B Datasheet Download
  • ·AD5040
  • AD [Analog Devices] 
  • Full Accurate 14/16 Bit Vout nanoDac Buffered, 3V/5V, Sot 23 
  • 849841 KB
  • AD5040 Datasheet Download
  • ·AD5060
  • AD [Analog Devices] 
  • Full Accurate 14/16 Bit Vout nanoDac Buffered, 3V/5V, Sot 23 
  • 849841 KB
  • AD5060 Datasheet Download
  • ·AD5061
  • AD [Analog Devices] 
  • Full Accurate 14/16 Bit Vout nanoDac Buffered, 3V/5V, Sot 23 
  • 849841 KB
  • AD5061 Datasheet Download
  • ·AD5062
  • AD [Analog Devices] 
  • Full Accurate 14/16 Bit Vout nanoDac Buffered, 3V/5V, Sot 23 
  • 849841 KB
  • AD5062 Datasheet Download
  • ·AD5063
  • AD [Analog Devices] 
  • Full Accurate 14/16 Bit Vout nanoDac Buffered, 3V/5V, Sot 23 
  • 849841 KB
  • AD5063 Datasheet Download

AD53509 Relative Products

  • AD53508JP

    AD53508JP

    IC DUAL PARAMETRIC MEASURE44PLCC

  • AD53508

    AD53508

    The AD53508 is a custom dual-channel parametric measurement circuit for use in semiconductor automatic test equipment.It contains programmable modes to force a pin voltage and measure its current or to integrate and hold a current value.Alternatively, a curr...

  • AD53502JSTP

    AD53502JSTP

    IC DCL MID PERFORMANCE

  • AD53500JRP

    AD53500JRP

    IC PIN DRIVER HI-CURR HS 20PSOPD

  • AD53500

    AD53500

    The AD53500 is a complete high speed driver designed for use in digital or mixed signal test systems where high speed and high output drive capabilities are needed. Combining a high speed monolithic process and a unique surface mount package, this product at...

  • AD534TH

    AD534TH

    IC PREC MULTIPLIER TO-100-10

Hotspot Suppliers Product

  • Models: AM29F010B-120PI
Price: 11.2-13.6 USD

    AM29F010B-120PI

    Price: 11.2-13.6 USD

    AM29F010B-120PI - 1 Megabit (128 K x 8-bit) CMOS 5.0 Volt-only, Uniform Sector Flash Memory - SPAN...

  • Models: BSM50GX120DN2
Price: 1-2 USD

    BSM50GX120DN2

    Price: 1-2 USD

    IGBT power module, Single switch, 1200 V Collector-emitter voltage, 78A DC collector current

  • Models: LM1042N
Price: 0.5-0.55 USD

    LM1042N

    Price: 0.5-0.55 USD

    Fluid Level Detector, DIP, 32V, 10 mA, 1.8W, Internally regulated supply

  • Models: AGN2004H
Price: 0.1-100 USD

    AGN2004H

    Price: 0.1-100 USD

    GN-relay, TELECOM DPDT, 1A, 4.5VDC, 2 Form C, Outstanding surge resistance

  • Models: BAT60B
Price: 0.028-0.032 USD

    BAT60B

    Price: 0.028-0.032 USD

    Silicon Schottky Diode, SOD-323, 10V

  • Models: EP9302-CQZ
Price: 12-15 USD

    EP9302-CQZ

    Price: 12-15 USD

    System-on-chip Processor, 208LQFP, 1.65 V ~ 3.6 V, 200MHz

  • Models: LBEE1DBRSC-369
Price: 1-2 USD

    LBEE1DBRSC-369

    Price: 1-2 USD

    LBEE1DBRSC-369, BGA, Integrated Circuits, Murata Manufacturing Co., Ltd.

  • Models: B10S
Price: 0.1-1.15 USD

    B10S

    Price: 0.1-1.15 USD

    mini surface mount, glass passivated, single-phase bridge rectifier, 0.5A, Low leakage

  • Models: IS42S32200C1-7TL
Price: 0.43-0.47 USD

    IS42S32200C1-7TL

    Price: 0.43-0.47 USD

    TSOP86, high speed CMOS, dynamic random-access memory, Fully synchronous, 64Mb

  • Models: ECQV1J104JM
Price: 0.1-0.15 USD

    ECQV1J104JM

    Price: 0.1-0.15 USD

    Stacked Metallized Film Capacitor, 0.010 μF to 2.2 μF, ±5 %, RoHS directive compliant

  • Models: PCA82C251T/N3
Price: 0.8-0.85 USD

    PCA82C251T/N3

    Price: 0.8-0.85 USD

    transmit capability, CAN transceiver, 24 V systems

  • Models: DS2152L
Price: 10-20 USD

    DS2152L

    Price: 10-20 USD

    Enhanced T1 Single-Chip Transceiver, 5V supply, low power CMOS, 100-pin 14mm2 body LQFP package

Map list:   ABCDEFGHIJKLMNOPQRSTUVWXYZ    0123456789All