|
Nominal Frequency | 9.600MHz to 40.000MHz |
The specified reference or "center" frequency of the oscillator. Typically specified in megahertz (MHz)or kilohertz (kHz). |
|
| Frequency Stability | | vs. Operating Temperature Range: | per Operating Temperature Ranges vs. Frequency Stabilities table below | | | vs. Input Voltage (±5%): | ±0.3ppm Maximum | | | vs. Load (±2pF): | ±0.2ppm Maximum | |
|
Operating Temperature Range | per Operating Temperature Ranges vs. Frequency Stabilities table below |
The maximum and minimum temperatures that the oscillator device can be exposed to during oscillation. Over thistemperature range, all of the specified device operatingparameters are guaranteed. |
|
Supply Voltage (VDD) | 3.3VDC ±5% |
The DC input voltage necessary for oscillator operation, specified involts. |
|
Input Current | 2mA Maximum from 9.600MHz to 27.000MHz 3mA Maximum from 27.000001MHz to 40.000MHz |
The amount of current consumption by an oscillator from the powersupply, typically specified in milliamps (mA). |
|
| Output Voltage | 0.7VP-P Minimum |
|
Load Drive Capability | 10kOhms//10pF |
The maximum load the oscillator can drive specified in terms of thenumber of gates or the type of load circuit (Figures 2, 3 and 4 in oscillator glossary of terms). |
|
Aging (at 25°C) | ±1ppm/year Maximum |
The systematic change in frequency with time due to internal changes in the crystal. Aging is often expressed as a maximum value in parts per million per year (ppm/yr). The rate of aging is typically greatest during the first 30 to 60 days after which time the aging rate decreases. The following factors effect crystal aging: adsorption and desorption of contamination on the surfaces of the quartz, stress relief of the mounting and bonding structures, material outgassing, and seal integrity. |
|
Storage Temperature | -40°C to +85°C |
The minimum and maximum temperatures that the device can be stored or exposed to when in a non-oscillation state. After exposing or storing the device at the minimum or maximum temperatures for a length of time, all of the operating specifications are guaranteed over the specified Operating Temperature Range. |
|
| Control Voltage (External) | 1.65VDC ±1.35VDC, Positive Transfer Characteristic |
|
| Frequency Deviation | ±7ppm Minimum, ±20ppm Maximum over Control Voltage (Referenced to FO at VC=1.65VDC; VDD=3.3VDC) |
|
| Internal Trim (Top of Can) | ±3ppm Minimum |
|
| Typical Phase Noise | -70dBc/Hz at offset of 10Hz -100dBc/Hz at offset of 100Hz -130dBc/Hz at offset of 1kHz -140dBc/Hz at offset of 10kHz -145dBc/Hz at offset of 100kHz |
|
| Modulation Bandwidth | 10kHz Minimum measured at -3dB with Control Voltage of 1.65VDC |
|
| Phase Noise | 10kOhms Typical |
|