Purchase G684, In-stock G684 From SeekIC.
Part Number: G684
Description: The G684/G685 are microprocessor (µP) supervisory circuits used to monitor the power supplies in...
- Table of contents:
G684
-
Suppliers
DataSheet
General Description
G684 General Description
The G684/G685 are microprocessor (µP) supervisory circuits used to monitor the power supplies in µP and digital systems. They provide excellent circuit reliability and low cost and adjustments when used with +5V, +3.3V, +3.0V- powered circuits.
These circuits perform a single function: they assert a reset signal whenever the VCC supply voltage declines below a preset threshold, with hysteresis after VCC has risen above the reset threshold. Reset thresholds suitable for operation with a variety of supply voltages are available.
The G685 has an open-drain output stage, while the G684 have push-pull outputs. The G685L's open-drain RESET output requires a pull-up resistor that can be connected to a voltage higher than VCC. The G684L have an active-low RESET output, while the G684H has an active-high RESET output. The reset comparator is designed to ignore fast transients on VCC, and the outputs are guaranteed to be in the correct logic state for VCC down to 0.8V. Low supply current makes the G684/G685 ideal for use in portable equipment. The G684/G685 are available in 5-pin SOT23-5 packages.
G684 Maximum Ratings
Terminal Voltage (with respect to GND)
VCC......................................-0.3V to +6.0V
Delay Capacitor Pin Voltage, VCD.............-0.3 to (VCC +0.3V)
RESET,RESET (push-pull).......................-0.3V to (VCC + 0.3V)
RESET (open drain)........................................-0.3V to +6.0V
Input Current, VCC ......................................................20mA
Output Current, RESET, RESET ......................................20mA
Continuous Power Dissipation (TA = +70)
5-Pin SOT23-5 (derate 2.17mW/ above +70)..........174mW
Operating Temperature Range ....................-40 to +105
Storage Temperature Range........................-65 to +150
Lead Temperature (soldering, 10s).........................+260
Stresses beyond those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
VCC......................................-0.3V to +6.0V
Delay Capacitor Pin Voltage, VCD.............-0.3 to (VCC +0.3V)
RESET,RESET (push-pull).......................-0.3V to (VCC + 0.3V)
RESET (open drain)........................................-0.3V to +6.0V
Input Current, VCC ......................................................20mA
Output Current, RESET, RESET ......................................20mA
Continuous Power Dissipation (TA = +70)
5-Pin SOT23-5 (derate 2.17mW/ above +70)..........174mW
Operating Temperature Range ....................-40 to +105
Storage Temperature Range........................-65 to +150
Lead Temperature (soldering, 10s).........................+260
Stresses beyond those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
G684 Features
· Precision Monitoring of +3V, +3.3V, and +5V Power-Supply Voltages
· Fully Specified Over Temperature
· Available in Three Output Configurations
Push-Pull RESET Output (G684L)
Push-Pull RESET Output (G684H)
Open-Drain RESET Output (G685L)
· 14µA Supply Current
· Guaranteed Reset Valid to VCC = 0.8V
· Power Supply Transient Immunity
· 5 pin SOT23-5 Packages
· 2% Threshold Accuracy
· Fully Specified Over Temperature
· Available in Three Output Configurations
Push-Pull RESET Output (G684L)
Push-Pull RESET Output (G684H)
Open-Drain RESET Output (G685L)
· 14µA Supply Current
· Guaranteed Reset Valid to VCC = 0.8V
· Power Supply Transient Immunity
· 5 pin SOT23-5 Packages
· 2% Threshold Accuracy
G684 Typical Application
· Computers
· Controllers
· Intelligent Instruments
· Critical µP and µC Power Monitoring
· Portable / Battery-Powered Equipment
· Automotive
· Controllers
· Intelligent Instruments
· Critical µP and µC Power Monitoring
· Portable / Battery-Powered Equipment
· Automotive
G684 Connection Diagram
G6849
PDF/DataSheet Download
- Datasheet: G6849
- File Size: 120307 KB
- Manufacturer: HAMAMATSU [Hamamatsu Corporation]
- Click here to Download
- ·G680
- ETC [ETC]
- Microprocessor Reset IC
- 103743 KB
- ·G681
- ETC [ETC]
- Microprocessor Reset IC
- 103743 KB
- ·G6849-01
- HAMAMATSU [Hamamatsu Corporation]
- InGaAs PIN photodiode
- 120307 KB
- ·G6854-01
- HAMAMATSU [Hamamatsu Corporation]
- InGaAs PIN photodiode
- 179690 KB
G684 Relative Products
G681
The G680/G681 are microprocessor (P) supervisory circuits used to monitor the power supplies in P and digital systems. High- and Low- voltage thresholds can be adjusted independently, allowing for wide hysteresis. Voltage detection thresholds are accurate to...
G680
The G680/G681 are microprocessor (P) supervisory circuits used to monitor the power supplies in P and digital systems. High- and Low- voltage thresholds can be adjusted independently, allowing for wide hysteresis. Voltage detection thresholds are accurate to...
G6742
G6718
The G6718 is designed for general purpose medium power amplifier and switching applications.
G671
The G670/G671 are microprocessor (P) supervisory circuits used to monitor the power supplies in P and digital systems. G670/G671 provide excellent circuit reliability and low cost by eliminating external components and adjustments when used with +5V, +3.3V, ...
G670
The G670/G671 are microprocessor (P) supervisory circuits used to monitor the power supplies in P and digital systems. G670/G671 provide excellent circuit reliability and low cost by eliminating external components and adjustments when used with +5V, +3.3V, ...
Hotspot Suppliers Product
S1D13806F00A1
Price: 1.35-2.35 USD
controller IC, TQFP-144, –0.3 to 7.0V, 300 mW, S1D13806F00A1, Epson
ADS7811U-1
Price: 1-4 USD
16-Bit, 250kHz, Sampling CMOS analog-to-digital converter, SOP28, 84dB min SINAD
TLP280-4GB
Price: 3-5 USD
small and thin coupler, photo transistor, optically coupled
MBR2045
Price: 0.23-0.31 USD
20 Amp, Schottky Barrier Rectifier, 20 to 100 Volts, TO-220, Low power loss, high efficiency, 20A ...
DTC143EKA146
Price: 0.03-0.1 USD
DTC143EKAT146, ROHM Semiconductor, Transistors Switching, Biased Resistor, NPN, 50V, 100MA
REF43G
Price: 1.5-4.5 USD
low-power precision reference, 2.5V, low temperature coefficient, 450μA
1SMB5919BT3G
Price: 0.0444-0.0556 USD
3 Watt, plastic surface mount, zener voltage regulator, DO214, 5.6V, RoHS Compliant
MCZ33661EFR2
Price: 4-10 USD
interface physical, 8-SOIC, physical Layer component, 6.0V to 18V DC
SG-8002JC
Price: 0.45-0.55 USD
PROGRAMMABLE HIGH-FREQUENCY CRYSTAL OSCILLATOR OSCILLATOR CMOS PROG 5V OE SMD - SG-8002JC
AD7711ANZ
Price: 1-10 USD
Signal Conditioning ADC, DIP, 24 Bits
TC7W241FU
Price: 0.35-0.45 USD
TC7W241FU - NON-INVERTED, 3-STATE OUTPUTS - Toshiba Semiconductor
MIC5377YC5 TR
Price: 0.2-0.22 USD
High Performance, Low Dropout, 150mA, SC70-5, 0V to 6V Supply Voltage, ESD Rating 2kV
