HCNW4504

Packaging : Tube
Maximum Input Diode Current : 25 mA
Maximum Power Dissipation : 100 mW
Minimum Operating Temperature : - 55 C
Maximum Reverse Diode Voltage : 3 V
Maximum Operating Temperature : + 85 C
Maximum Baud Rate : 1 Mbps
Maximum Forward Diode Voltage : 1.85 V
Package / Case : PDIP-8
Current Transfer Ratio : 65 %


Features:

• Short Propagation Delays for TTL and IPM Applications
• 15 kV/ms Minimum Common Mode Transient Immunity at V_CM = 1500 V for TTL/Load Drive
• High CTR at T_A = 25°C
>25% for HCPL-4504/0454
>23% for HCNW4504
• Electrical Specifications for Common IPM Applications
• TTL Compatible
• Guaranteed Performance from 0°C to 70°C
• Open Collector Output
• Safety Approval
UL Recognized - 2500 V rms
for 1 minute (5000 V rms for 1 minute for
HCPL-4504#020 and
HCNW4504)per UL1577
CSA Approved
VDE 0884 Approved
-V_IORM = 630 V_peak for HCPL-4504#060
-V_IORM = 1414 V_peak for HCNW4504
BSI Certified (HCNW4504)
• Available in 8-Pin DIP, SO-8, Widebody Packages




Application

• Inverter Circuits and Intelligent Power Module (IPM) interfacing -
High Common Mode Transient Immunity (> 10 kV/ms for an IPM load/drive) and (t_PLH - t_PHL) Specified (See Power Inverter Dead Time section)
• Line Receivers -Short Propagation Delays and Low Input-Output Capacitance
• High Speed Logic Ground Isolation - TTL/TTL, TTL/ CMOS, TTL/LSTTL
• Replaces Pulse Transformers - Save Board Space and Weight
• Analog Signal Ground Isolation - Integrated Photodetector Provides Improved Linearity over Phototransistors




Pinout






Specifications

Parameter	Symbol	Device	Min.	Max.	Units	Note
Storage Temperature	TS		-55	125	°C
Operating Temperature	TA	HCPL-4504 HCPL-0454 HCNW4504	-55 -55	100 85	°C
Average Forward Input Current	IF(avg)			25	mA	1
Peak Forward Input Current (50% duty cycle, 1 ms pulse width) (50% duty cycle, 1 ms pulse width)	IF(PEAK)	HCPL-4504 HCPL-0454 HCNW4504		50 40	mA	2
Peak Transient Input Current (£ 1 ms pulse width, 300 pps)	IF(TRANS)	HCPL-4504 HCPL-0454 HCNW4504		0.1 1	A
Reverse LED Input Voltage (Pin 3-2)	VR	HCPL-4504 HCPL-0454 HCNW4504		5 3	v
Input Power Dissipation	PIN	HCPL-4504 HCPL-0454 HCNW4504		45 40	mw	3
Average Output Current (Pin 6)	IO(AVG)			8	mA
Peak Output Current (Pin 6)	IO(PEAK)			16	mA
Supply Voltage (Pin 8-5)	VCC		-0.8	30	V
Output Voltage (Pin 6-5)	VO		-0.5	20	V
Output Power Dissipation	PO			100	MW	4
Lead Solder Temperature 1.6 mm Below Seating Plane, 10 Seconds up to Seating Plane, 10 Seconds	TLS	HCPL-4504 HCNW4504		260 260	°C °C
Reflow Temperature Profile	TRP	HCPL-0454 and Option 300	See Package Outline Drawings section

Description

HCPL-4504 series  contains an AlGaAs LED. The LED is optically coupled to an integrated high gain photo detector.

The HCPL-4504 series has short propagation delays and high CTR. The HCPL-4504 series also has a guaranteed propagation delay difference (tPLH-tPHL). These features make the HCPL-4504 series an excellent solution to IPM inverter dead time and other switching problems.The CTR, propagation delay, and CMR are specified both for TTL and IPM conditions which are provided for ease of application. This single channel, diode-transistor optocoupler is available in a Widebody package. An insulating layer between a LED and an integrated photodetector provides electrical insulation between input and output. Separate connections for the photodiode bias and output-transistor collector increase the speed up to a hundred times that of a conventional phototransistor coupler by reducing the base collector capacitance.

Parameters:

Technical/Catalog Information	HCNW4504
Vendor	Avago Technologies US Inc.
Category	Isolators
Voltage - Isolation	5000Vrms
Input Type	DC
Output Type	Transistor with Vcc
Current - Output / Channel	8mA
Voltage - Output	20V
Vce Saturation (Max)	-
Current Transfer Ratio (Min)	19% @ 16mA
Mounting Type	Through Hole
Package / Case	8-DIP (400 mil)
Packaging	Tube
Number of Circuits	1 - Single
Lead Free Status	Contains Lead
RoHS Status	RoHS Non-Compliant
Other Names	HCNW4504 HCNW4504 516 1037 5 ND 51610375ND 516-1037-5