High Speed Optocouplers 5MBd 1Ch 1.6mA
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Maximum Baud Rate : | 5 MBps | Maximum Forward Diode Voltage : | 1.7 V | ||
Maximum Reverse Diode Voltage : | 5 V | Maximum Power Dissipation : | 210 mW | ||
Maximum Operating Temperature : | + 85 C | Minimum Operating Temperature : | - 40 C | ||
Package / Case : | PDIP-8 | Packaging : | Tube |
Parameter |
Symbol |
Minimum |
Maximum |
Units |
Note |
Storage Temperature |
TS |
-55 |
125 |
°C |
|
Operating Temperature |
TA |
-40 |
85 |
°C |
1 |
Average Forward Input Current |
I F(AVG) |
10 |
mA |
||
Peak Transient Input Current ( 1 ms Pulse Width, 300 pps) |
IF(tran) |
1.0 |
A |
||
Reverse Input Voltage |
VR |
5 |
V |
||
Average Output Current |
IO |
25 |
mA |
||
Supply Voltage |
VCC |
0 |
20 |
V |
|
Three State Enable Voltage |
VE |
-0.5 |
20 |
V |
|
Output Voltage |
VO |
-0.5 |
20 |
V |
|
Total Package Power Dissipation |
PT |
210 |
mW |
1 | |
Lead Solder Temperature |
260°C for 10 sec., 1.6 mm below seating plane |
||||
Solder Reflow Temperature Profile |
See Package Outline Drawings section |
The HCPL-2200 is an optically coupled logic gate that combines a GaAsP LED and an integrated high gain photodetector. The detector has a three state output stage and has a detector threshold with hysteresis. The three state output eliminates the need for a pullup resistor and allows for direct drive of data busses. The hysteresis provides differential mode noise immunity and eliminates the potential for output signal chatter.
The Electrical Switching Characteristics of the HCPL-2200 are guaranteed over the temperature range of 0 degrees C to 85 degrees C and a VCC range of 4.5 volts to 20 volts. Low IF and wide VCC range allow compatibility with TTL, LSTTL, and CMOS logic and result in lower power consumption compared to other high speed optocouplers. Logic signals are transmitted with a typical propagation delay of 160 nsec.
HCPL-2200 is useful for isolating high speed logic interfaces, buffering of input and output lines, and implementing isolated line receivers in high noise environments.
Technical/Catalog Information | HCPL-2200 |
Vendor | Avago Technologies US Inc. |
Category | Isolators |
Mounting Type | Through Hole |
Package / Case | 8-DIP |
Isolation Voltage | 3750Vrms |
Configuration | 1, One Direction |
Input Type | DC |
Output Type | Tri-State |
Data Rate | 2.5Mbs |
Current - Output/Channel | 25mA |
Packaging | Tube |
Lead Free Status | Contains Lead |
RoHS Status | RoHS Non-Compliant |
Other Names | HCPL 2200 HCPL2200 516 1053 5 ND 51610535ND 516-1053-5 |