IRL2703PbF

      The IRL2703PBF has the following features including logic-level gate drive;advanced process technology;dynamic dv/dt rating;fast switching;fully avalanche rated;lead-free.
      A stop condition is indicated when the bus master drives IRL2703PBF DA from low to high while the IRL2703PBF CL signal is high. All operations using the IRL2703PBF must end with a IRL2703PBFtop condition. If an operation is pending when a IRL2703PBFtop is asserted, the operation will be aborted. The master must have control of IRL2703PBFDA (not a memory read) in order to assert a IRL2703PBFtop condition.Inputs Are TTL-Voltage Compatible Flow-Through Architecture to Optimize PCB Layout Center-Pin VCC and GND Configurations Minimize High-Speed Switching Noise EPICt (Enhanced-Performance Implanted CMOS) 1-mm Process 500-mA Typical Latch-Up Immunity at 125C Package Options Include Plastic Small-Outline Packages, Ceramic Chip Carriers, and Standard Plastic and Ceramic 300-mil DIPs. 
      This parameter is warranted but not production tested. The propagation delay is based on the RC time constant of the typical On-State resistance of the switch and a load capacitance of 50pF, when driven by an ideal voltage source (zero output impedance).  The ABT16543 16-bit registered transceivers contain two sets of D-type latches for temporary storage of data flowing in either direction. The ABT16543 can be used as two 8-bit transceivers or one 16-bit transceiver. Separate latch-enable (LEAB or LEBA) and output-enable (OEAB or OEBA) inputs are provided for each register to permit independent control in either direction of data flow.The information provided on this page represents TI's knowledge and belief as of the date that it is provided. TI bases its knowledge and belief on information provided by third parties, and makes no representation or warranty as to the accuracy of such information. Efforts are underway to better integrate information from third parties. TI has taken and continues to take reasonable steps to provide representative and accurate information but may not have conducted destructive testing or chemical analysis on incoming materials and chemicals. TI and TI suppliers consider certain information to be proprietary, and thus CAS numbers and other limited information may not be available for release.