Purchase M95640-W, In-stock M95640-W From SeekIC.
Part Number: M95640-W
Description: During all operations, VCC must be held stable and within the specified valid range: VCC(min) to VCC(max). All of the i...
- Table of contents:
M95640-W
-
Suppliers
DataSheet
General Description
M95640-W General Description
During all operations, VCC must be held stable and within the specified valid range: VCC(min) to VCC(max). All of the input and output signals must be held
High or Low (according to voltages of VIH, VOH, VIL or VOL, as specified in Table 16. to Table 20.).These signals are described nextSerial Data Output (Q). This output signal is used to transfer data serially out of the device. Data is shifted out on the falling edge of Serial Clock (C).
Serial Data Input (D). This input signal is used to transfer data serially into the device. It receives in-structions, addresses, and the data to be written. Values are latched on the rising edge of Serial Clock (C).
Serial Clock (C). This input signal provides the timing of the serial interface. Instructions, address-es, or data present at Serial Data Input (D) are latched on the rising edge of Serial Clock (C). Data on Serial Data Output (Q) changes after the falling edge of Serial Clock (C).
M95640-W Maximum Ratings
| Symbol | Parameter | Min. | Max. | Unit |
| TSTG | Storage Temperature | 65 | 150 | °C |
| TLEAD | Lead Temperature during Soldering | See note 1 | °C | |
| VO | Output Voltage | 0.50 | VCC+0.6 | V |
| VI | Input Voltage | 0.50 | 6.5 | V |
| VCC | Supply Voltage | 0.50 | 6.5 | V |
| VESD | Electrostatic Discharge Voltage (Human Body model)2 | 4000 | 4000 | V |
M95640-W Features
Compatible with SPI Bus Serial Interface (Positive Clock SPI Modes)
Single Supply Voltage:
4.5 to 5.5V for M95320 and M95640
2.5 to 5.5V for M95320-W and M95320-W
1.8 to 5.5V for M95320-R and M95640-R
1.65 to 5.5V for M95320-S and M95640-S
20MHz, 10MHz, 5MHz or 2MHz clock rates
5ms or 10ms Write Time
Status Register
Hardware Protection of the Status Register
BYTE and PAGE WRITE (up to 32 Bytes)
Self-Timed Programming Cycle
Adjustable Size Read-Only EEPROM Area
Enhanced ESD Protection
More than 100000 or 1 million Erase/Write Cycles (depending on ordering options)
More than 40-Year Data Retention
Single Supply Voltage:
4.5 to 5.5V for M95320 and M95640
2.5 to 5.5V for M95320-W and M95320-W
1.8 to 5.5V for M95320-R and M95640-R
1.65 to 5.5V for M95320-S and M95640-S
20MHz, 10MHz, 5MHz or 2MHz clock rates
5ms or 10ms Write Time
Status Register
Hardware Protection of the Status Register
BYTE and PAGE WRITE (up to 32 Bytes)
Self-Timed Programming Cycle
Adjustable Size Read-Only EEPROM Area
Enhanced ESD Protection
More than 100000 or 1 million Erase/Write Cycles (depending on ordering options)
More than 40-Year Data Retention
M95640-W
PDF/DataSheet Download
- Datasheet: M95640-W
- File Size: 545042 KB
- Manufacturer: STMicroelectronics
- Click here to Download
- ·M95010
- STMICROELECTRONICS [STMicroelectronics]
- 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
- 601078 KB
- ·M95010BN
- STMICROELECTRONICS [STMicroelectronics]
- 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
- 545372 KB
- ·M95010-BN3
- STMICROELECTRONICS [STMicroelectronics]
- 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
- 601078 KB
- ·M95010-BN3/W
- STMICROELECTRONICS [STMicroelectronics]
- 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
- 601078 KB
- ·M95010-BN3G
- STMICROELECTRONICS [STMicroelectronics]
- 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
- 601078 KB
- ·M95010-BN3G/W
- STMICROELECTRONICS [STMicroelectronics]
- 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
- 601078 KB
- ·M95010-BN3P
- STMICROELECTRONICS [STMicroelectronics]
- 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
- 601078 KB
- ·M95010-BN3P/W
- STMICROELECTRONICS [STMicroelectronics]
- 4Kbit, 2Kbit and 1Kbit Serial SPI Bus EEPROM With High Speed Clock
- 601078 KB
M95640-W Relative Products
M95640-S
During all operations, VCC must be held stable and within the specified valid range: VCC(min) to VCC(max). All of the input and output signals must be heldHigh or Low (according to voltages of VIH, VOH, VIL or VOL, as specified in Table 16. to Table 20.).The...
M95640-RMN6TP
IC EEPROM SER SPI 64KBIT SO-8
M95640-RMB6TG
IC EEPROM 64KBIT SER SPI 8-MLP
M95640-RDW6TP
EEPROM 64KBIT SER SPI 8-TSSOP
M95640-R
During all operations, VCC must be held stable and within the specified valid range: VCC(min) to VCC(max). All of the input and output signals of M95640-R must be heldHigh or Low (according to voltages of VIH, VOH, VIL or VOL, as specified in Table 16. to Ta...
M95640
During all operations, VCC must be held stable and within the specified valid range: VCC(min) to VCC(max). All of the input and output signals must be heldHigh or Low (according to voltages of VIH, VOH, VIL or VOL, as specified in Table 16. to Table 20.).The...
Hotspot Suppliers Product
SNJ54LS123J
Price: 4-10 USD
d-c triggered multivibrator, external resistance, DC triggered
X22C12P
Price: 0.75-3 USD
Nonvolatile Static RAM, DIP, –1V to +7V, 150ns, High Reliability, High Performance
PIC18F252-I/P
Price: 3-3.62 USD
DIP-28, High Performance, Enhanced FLASH Microcontrollers, 10-Bit A/D, -0.3V to +7.5V
PIC16F887-I/P
Price: 1.5-1.6 USD
8-Bit, CMOS Microcontroller, TQFP packages
GCA200AA60
Price: 1-1 USD
IGPT module, 600V, 200A
962UA
Price: 22-35 USD
962UA, laptop ic chip, BGA, Silicon Integrated Systems
74LVC1G57GW.125
Price: 0.001-2 USD
gate, SOT, -0.5 to +6.5 V
DM9102DEP
Price: 0.5-0.95 USD
fully integrated, cost effective, single chip, Fast Ethernet NIC controller, QFP, -0.3 to 3.6 V, 1...
SST39VF040-70-4C-NHE
Price: 1-20 USD
Multi-Purpose Flash, CMOS I/O Compatibility, PLCC, Internal VPP Generation, 14MHz
AT91SAM7S256-AU
Price: 6-7.5 USD
Microcontroller, QFP, 16-bit
SIM908
Price: 15-21 USD
complete Quad-Band GSM/GPRS module
VI-261-EU
Price: 30-35 USD
MODULE, Battery Charger Current Source Module, Analog Overvoltage Adjust, CE Marked
