Purchase MBM29LV001BC-70, In-stock MBM29LV001BC-70 From SeekIC.
Part Number: MBM29LV001BC-70
Description: The MBM29LV001TC/BC have two control functions which must be satisfied in order to obtain data at the ...
- Table of contents:
MBM29LV001BC-70
-
Suppliers
DataSheet
General Description
MBM29LV001BC-70 General Description
The MBM29LV001TC/BC have two control functions which must be satisfied in order to obtain data at the outputs. CE is the power control and should be used for a device selection. OE is the output control and should be used to gate data to the output pins if a device is selected.
Address access time (tAcc) is equal to the delay from stable addresses to valid output data. The chip enable access time (tCE) is the delay from stable addresses and stable CE to valid data at the output pins. The output enable access time is the delay from the falling edge of OE to valid data at the output pins. (Assuming the addresses have been stable for at least tAcc-tOE time.) When reading out a data without changing addresses after power-up, it is necessary to input hardware reset or change CE pin from "H" or "L"
MBM29LV001BC-70 Maximum Ratings
Storage Temperature ..........................................................................................55°C to +125°C
Ambient Temperature with Power Applied .............................................................40°C to +85°C
Voltage with respect to Ground All pins except A9, OE and RESET (Note 1) .......0.5 V to VCC+0.5 V
VCC (Note 1) .............................................................................................................0.5 V to +5.5 V
A9, OE, and RESET (Note 2) ....................................................................................0.5 V to +13.0 V
Notes: 1. Minimum DC voltage on input or I/O pins are 0.5 V. During voltage transitions, inputs may negative overshoot VSS to 2.0 V for periods of up to 20 ns. Maximum DC voltage on output and I/O pins are Vcc +0.5 V. During voltage transitions, outputs may positive overshoot to VCC +2.0 V for periods of up to 20 ns.
2. Minimum DC input voltage on A9, OE and RESET pins are 0.5 V. During voltage transitions, A9, OE and RESET pins may negative overshoot VSS to 2.0 V for periods of up to 20 ns. Maximum DC input voltage on A9, OE and RESET pins are +13.0 V which may positive overshoot to 14.0 V for periods of up to 20 ns. Voltage difference between input voltage and supply voltage (VIN Vcc) do not exceed 9 V.
WARNING: Semiconductor devices can be permanently damaged by application of stress (voltage, current, temperature, etc.) in excess of absolute maximum ratings. Do not exceed these ratings.
MBM29LV001BC-70 Features
• Single 3.0 V read, program, and erase
Minimizes system level power requirements
• Compatible with JEDEC-standard commands
Uses same software commands as E2PROMs
• Compatible with JEDEC-standard world-wide pinouts
32-pin TSOP(I) (Package suffix: PFTN Normal Bend Type, PFTR Reversed Bend Type)
32-pin PLCC (Package suffix: PD)
• Minimum 100,000 program/erase cycles
• High performance
55 ns maximum access time
• Sector erase architecture
One 8K byte, two 4K bytes, and seven 16K bytes
Any combination of sectors can be concurrently erased. Also supports full chip erase
• Boot Code Sector Architecture
T = Top sector
B = Bottom sector
• Embedded EraseTM Algorithms
Automatically pre-programs and erases the chip or any sector
• Embedded ProgramTM Algorithms
Automatically writes and verifies data at specified address
•Data Polling and Toggle Bit feature for detection of program or erase cycle completion
• Hardware RESET pin
Resets internal state machine to the read mode
• Automatic sleep mode
When addresses remain stable, automatically switch themselves to low power mode
• Low Vcc write inhibit 2.5 V
• Erase Suspend/Resume
Suspends the erase operation to allow a read data in another sector within the same device
• Sector protection
Hardware method disables any combination of sectors from program or erase operations
• Sector Protection Set function by Extended sector protection command
• Temporary sector unprotection
Temporary sector unprotection via the RESET pin
Minimizes system level power requirements
• Compatible with JEDEC-standard commands
Uses same software commands as E2PROMs
• Compatible with JEDEC-standard world-wide pinouts
32-pin TSOP(I) (Package suffix: PFTN Normal Bend Type, PFTR Reversed Bend Type)
32-pin PLCC (Package suffix: PD)
• Minimum 100,000 program/erase cycles
• High performance
55 ns maximum access time
• Sector erase architecture
One 8K byte, two 4K bytes, and seven 16K bytes
Any combination of sectors can be concurrently erased. Also supports full chip erase
• Boot Code Sector Architecture
T = Top sector
B = Bottom sector
• Embedded EraseTM Algorithms
Automatically pre-programs and erases the chip or any sector
• Embedded ProgramTM Algorithms
Automatically writes and verifies data at specified address
•Data Polling and Toggle Bit feature for detection of program or erase cycle completion
• Hardware RESET pin
Resets internal state machine to the read mode
• Automatic sleep mode
When addresses remain stable, automatically switch themselves to low power mode
• Low Vcc write inhibit 2.5 V
• Erase Suspend/Resume
Suspends the erase operation to allow a read data in another sector within the same device
• Sector protection
Hardware method disables any combination of sectors from program or erase operations
• Sector Protection Set function by Extended sector protection command
• Temporary sector unprotection
Temporary sector unprotection via the RESET pin
MBM29LV001BC-70 Connection Diagram
MBM29LV001BC-70
PDF/DataSheet Download
- Datasheet: MBM29LV001BC-70
- File Size: 431274 KB
- Manufacturer: FUJITSU [Fujitsu Media Devices Limited]
- Click here to Download
- ·MBM100A6
- HITACHI [Hitachi Semiconductor]
- IGBT MODULE RANGE WITH SOFT AND FAST (SFD) FREE-WHEELING DIODES
- 79491 KB
- ·MBM100F12
- HITACHI [Hitachi Semiconductor]
- IGBT MODULE RANGE WITH SOFT AND FAST (SFD) FREE-WHEELING DIODES
- 79491 KB
- ·MBM150A6
- HITACHI [Hitachi Semiconductor]
- IGBT MODULE RANGE WITH SOFT AND FAST (SFD) FREE-WHEELING DIODES
- 79491 KB
- ·MBM150F12
- HITACHI [Hitachi Semiconductor]
- IGBT MODULE RANGE WITH SOFT AND FAST (SFD) FREE-WHEELING DIODES
- 79491 KB
- ·MBM200A6
- HITACHI [Hitachi Semiconductor]
- IGBT MODULE RANGE WITH SOFT AND FAST (SFD) FREE-WHEELING DIODES
- 79491 KB
- ·MBM2212-20
- FUJITSU [Fujitsu Media Devices Limited]
- MOS 1024 BIT NON VOLATILE RANDOM ACCESS MEMORY
- 373835 KB
- ·MBM2212-25
- FUJITSU [Fujitsu Media Devices Limited]
- MOS 1024 BIT NON VOLATILE RANDOM ACCESS MEMORY
- 373835 KB
- ·MBM2732-45
- Fujitsu
- 470965 KB
MBM29LV001BC-70 Relative Products
MBM29LV001BC-55
The MBM29LV001BC-55 have two control functions which must be satisfied in order to obtain data at the outputs.CE is the power control and should be used for a device selection.OE is the output control and should be used to gate data to the output pins if a d...
MBM29F800TA90
The MBM29F800TA90 is a 8M-bit, 5.0 V-only Flash memory organized as 1M bytes of 8 bits each or 512K words of 16 bits each. The MBM29F800TA/BA is offered in a 48-pin TSOP(I) and 44-pin SOP packages. Thisdevice is designed to be programmed in-system with the s...
MBM29F800TA70
The MBM29F800TA70 is a 8M-bit, 5.0 V-only Flash memory organized as 1M bytes of 8 bits each or 512K words of 16 bits each. The MBM29F800TA/BA is offered in a 48-pin TSOP(I) and 44-pin SOP packages. Thisdevice is designed to be programmed in-system with the s...
MBM29F800TA55
The MBM29F800TA55 is a 8M-bit, 5.0 V-only Flash memory organized as 1M bytes of 8 bits each or 512K words of 16 bits each. The MBM29F800TA/BA is offered in a 48-pin TSOP(I) and 44-pin SOP packages. Thisdevice is designed to be programmed in-system with the s...
MBM29F800BA90
The MBM29F800BA90 is a 8M-bit, 5.0 V-only Flash memory organized as 1M bytes of 8 bits each or 512K words of 16 bits each. The MBM29F800TA/BA is offered in a 48-pin TSOP(I) and 44-pin SOP packages. Thisdevice is designed to be programmed in-system with the s...
MBM29F800BA70
The MBM29F800BA70 is a 8M-bit, 5.0 V-only Flash memory organized as 1M bytes of 8 bits each or 512K words of 16 bits each. The MBM29F800TA/BA is offered in a 48-pin TSOP(I) and 44-pin SOP packages. Thisdevice is designed to be programmed in-system with the s...
Hotspot Suppliers Product
PIC12F629-I/SN
Price: 0.43-0.45 USD
8-Bit CMOS Microcontroller, SOP-8PIN, -0.3 to +6.5V, 250 mA, Wide Operating Voltage Range
UAA1041B
Price: 0.6-1 USD
automotive direction indicator, Defective Lamp Detection, Overvoltage Protection
FS14SM-16A
Price: 1-4 USD
TO-3P, Nch power MOSFET, 800V, 0.70W, 14A
MC68HC11A0FN
Price: 0.1-20 USD
high-performance microcontroller unit, PLCC52, –0.3 to + 7.0 V, 8 Kbytes ROM, M68HC11 CPU
MAX1487ESA+
Price: 0.01-1.5 USD
low-power transceivers, one driver, one receiver
PC87417-ICK-VLA
Price: 4.55-5.65 USD
LPC ServerI/O for Servers and Workstations PC87417-ICK-VLA
SP10150S
Price: 2-3 USD
150V, 10.0 AMP, schottky barrier rectifier, TO247, Low forward voltage drop
PKL4110PIT
Price: 15.02-22.32 USD
DC/DC converters, Input 36-75 V, Output 100 A/300 W, Low output ripple 60 mVp-p
74LVC08AD
Price: 0.1-1 USD
Si-gate CMOS device, 1.2 to 3.6 V, SOP
IPS1583BS
Price: 1-10000000 USD
IPS1583BS, QFN, Integrated Circuits, NXP Semiconductors
ATMEGA8L-8AU
Price: 1-2 USD
microcontroller, 8-bit, TQFP32
DMF-50262NF-FW
Price: 200-250 USD
LCD Module; Cold Cathode Fluorescent Lamp (CFL) as backlight; F-STN / Black & White-mode / Tra...
