MX29F001T/B

      The MX29F001T/B is a 1-mega bit Flash memory organized as 128K bytes of 8 bits only MXIC's Flash memories offer the most cost-effective and reliable read/write non-volatile random access memory. The MX29F001T/B is packaged in 32-pin PLCC, TSOP, PDIP. It is designed to be reprogrammed and erased in-system or in-standard EPROM programmers.Here you can get some information about the features.First,it uses a 5.0V ± 10% VCC supply for read, erase and write operation.Secondly,it offers access time 90ns.Thirdly, it has low power consumption.The maximum active current(5MHz) is 30mA and the typical standby current is 1A.Fourthly,it has the function of auto erase (chip & sector) and auto program which means it can automatically erase any combination of sectors with Erase Suspend capability and can automatically programs and verifies data at specified address.Fifthly, it has the erase suspend/erase resume function which means it can suspend an erase operation to read data from,or program data to, a sector that is not being erased, then resumes the erase operation.Sixthly,latch-up protection is proved for stresses up to 100 milliamps on address and data pin from -1V to VCC+ 1V.The seventh one is that the low VCC write inhibit is equal to or less than 3.2 V.The last one is that it has 100,000 minimum erase/program cycles.
      What comes next is about the absolute maximum ratings.The Ambient Operating Temperature is from 0 to 70.The Storage Temperature is from -65 to 125.The Applied Input Voltage is from -0.5 to 7.0 V.The Applied Output Voltage is from -0.5 to 7.0 V.The V_CC to Ground Potential is from -0.5 to 7.0 V.Then is about the capacitance (TA=25,f = 1.0 MHz).The Maximum Input Capacitance (C_IN1) is 8 pF at VIN = 0V.The Maximum Control Pin Capacitance (C_IN2) is 12 pF at VIN = 0V.The Maximum Output Capacitance (C_OUT) is 12 pF at V_OUT = 0V.The following is about the DC characteristics.The Maximum Input Leakage Current (I_LI) is 1 A at V_IN = GND to V_CC.The Maximum Output Leakage Current (I_LO ) is 10 A at V_OUT = GND to VCC.The Maximum Standby V_CC current (I_SB1 ) is 1 mA at CE = V_IH;The Typical Standby V_CC current (I_SB2 ) is 1A and the maximum is 5A at CE = V_CC + 0.3V.The Minimum Input Low Voltage (V_IL) is -0.3 V and the maximum is 0.8 V.The Minimum Input High Voltage (V_IH) is 2.0 and the maximum is V_CC + 0.3 V.The Maximum Output Low Voltage (V_OL) is 0.45 V at I_OL = 2.1mA.