NPe405L

Features: • IBM PowerPCTM 405 32-bit RISC processorcore operating up to 266 MHz• PC-100 Synchronous DRAM (SDRAM) interface operating up to 133 MHz - 32-bit interface for non-ECC applications - 40-bit interface serves 32 bits of data plus 8 check bits for ECC applications• Externa...

product image

NPe405L Picture
SeekIC No. : 004435128 Detail

NPe405L: Features: • IBM PowerPCTM 405 32-bit RISC processorcore operating up to 266 MHz• PC-100 Synchronous DRAM (SDRAM) interface operating up to 133 MHz - 32-bit interface for non-ECC applicat...

floor Price/Ceiling Price

Part Number:
NPe405L
Supply Ability:
5000

Price Break

  • Qty
  • 1~5000
  • Unit Price
  • Negotiable
  • Processing time
  • 15 Days
Total Cost: $ 0.00

SeekIC Buyer Protection PLUS - newly updated for 2013!

  • Escrow Protection.
  • Guaranteed refunds.
  • Secure payments.
  • Learn more >>

Month Sales

268 Transactions

Rating

evaluate  (4.8 stars)

Upload time: 2024/5/19

Payment Methods

All payment methods are secure and covered by SeekIC Buyer Protection PLUS.

Notice: When you place an order, your payment is made to SeekIC and not to your seller. SeekIC only pays the seller after confirming you have received your order. We will also never share your payment details with your seller.
Product Details

Description



Features:

• IBM PowerPCTM 405 32-bit RISC processorcore operating up to 266 MHz
• PC-100 Synchronous DRAM (SDRAM) interface operating up to 133 MHz
    - 32-bit interface for non-ECC applications
    - 40-bit interface serves 32 bits of data plus 8 check bits for ECC applications
• External Peripheral Bus
    - Flash ROM/Boot ROM interface
    - Direct support for 8-, or 16-bit SRAM and external peripherals
    - Up to 4 banks
• DMA support for external peripherals, internal UARTs and memory
    - Scatter-gather chaining supported
    - Four channels
• 2 Ethernet 10/100Mbps (full-duplex) units with a choice of MII, RMII, or SMII interfaces.
• HDLC interface with 32 channels through 2 ports
• Programmable Interrupt Controllers supports interrupts from a variety of sources
    - Seven external and 29 internal
    - Edge triggered or level-sensitive
    - Positive or negative active
    - Non-critical or critical interrupt to processor core
    - Programmable critical interrupt priority ordering
    - Programmable critical interrupt vector for faster vector processing
• Programmable Timers
• Two serial ports (16550 compatible UART)
• One IIC (I2C) interface
• General Purpose I/O (GPIO) available
• Supports JTAG for board level testing
• Internal Processor Local Bus (PLB) runs at SDRAM interface frequency



Specifications

Characteristic Symbol Value Unit
Supply Voltage (Internal Logic) VDD 0 to 2.7 V
Supply Voltage (I/O Interface) OVDD 0 to 3.6 V
PLL Supply Voltage AVDD 0 to 2.7 V
Input Voltage (3.3V LVTTL receivers) VIN 0 to 3.6 V
Input Voltage (5.0V LVTTL receivers) VIN 0 to 5.5 V
Storage Temperature Range TSTG -55 to 150 °C
Case temperature under bias TC -40 to +120 °C



Description

Designed specifically to address embedded applications, the NPe405L provides a highperformance, low-power solution that interfaces to a wide range of peripherals by incorporating on-chip power management features and intrinsically lower power dissipation requirements.

This NPe405L chip contains a high-performance RISC processor core, SDRAM controller, Ethernet interfaces, HDLC interface, control for external ROM and peripherals, DMA with scatter-gather support, serial ports, IIC interface, and general purpose I/O.

Technology: IBM CMOS 6SF 0.25µm(0.18µm Leff)

Package: 324-ball (23mm) enhanced plastic ball grid array (E-PBGA)

Power (estimated): Typical 1.1W, Maximum ?.?W




Customers Who Bought This Item Also Bought

Margin,quality,low-cost products with low minimum orders. Secure your online payments with SeekIC Buyer Protection.
Line Protection, Backups
Motors, Solenoids, Driver Boards/Modules
Programmers, Development Systems
Soldering, Desoldering, Rework Products
Connectors, Interconnects
Cable Assemblies
View more