PEB20321

32-channel HDLC controller with PCI interface:
• Serial PCM core
Up to 32 independent full-duplex channels
Serial PCM traffic at 2.048, 4.096, 1.544, 1.536,
3.088, 6.176 or 8.192-Mbit/s
• Dynamic Programmable Channel Allocation
Compatible with T1/DS1 24-channel and CEPT 32- channel PCM byte format
Concatenation of any, not necessarily consecutive, time slots to superchannels
independently for receive and transmit direction
Support of H0, H11, H12 ISDN-channels
Subchanneling on each time slot possible
• Bit Processor Functions (adjustable for each channel)
HDLC Protocol
Automatic flag detection
Shared opening and closing flag
Detection of interframe-time-fill change, generation of interframe-time-fill '1's or flags
Zero bit insertion
Flag stuffing and flag adjustment for rate adaption
CRC generation and checking (16 or 32 bits)
Transparent CRC option per channel and/or per message
Error detection (abort, long frame, CRC error, 2 categories of short frames, non-octet frame content)
ABORT/IDLE flag generation
V.110/X.30 Protocol
Automatic synchronization in receive direction, automatic generation of the synchronization pattern in transmit direction
E/S/X bits freely programmable in transmit direction, may be changed during transmission; changes monitored and reported in receive direction
Generation/detection of loss of synchronism
Bit framing with network data rates from 600 bit/s up to 38.4 Kbit/s
Transparent Mode A
Slot synchronous transparent transmission/reception without frame structure
Flag generation, flag stuffing, flag extraction, flag generation
in the abort case with programmable flag
Synchronized data transfer for fractional T1/PRI channels
Transparent Mode B
Transparent transmission/reception in frames delimited by 00H flags
Shared opening and closing flag
Flag stuffing, flag detection, flag generation in the abort case
Error detection (non octet frame content, short frame, long frame)
Transparent Mode R
Transparent transmission/reception with GSM 08.60 frame structure
Automatic 0000_H flag generation/detection
Support of 40, 391/2, 401/2 octet frames
Error detection (non octet frame contents, short frame, long frame)
Protocol Independent
Channel inversion (data, flags, IDLE code)
Format conventions as in CCITT Q.921 § 2.8
Data over- and underflow detected
• Microprocessor Interface
32-bit PCI bus interface option, 33 MHz
32-bit De-multiplexed bus interface option, 33 MHz
68 channel DMA controller (64 for 32 serial channels, 4 for 2 LBI channels) with buffer chaining capability
Master 4-DWORD burst read and write capability
Slave single-DWORD read and write capability
Interrupt-circular buffers with variable sizes
Maskable interrupts for each channel
• IOM®-2 Interface with on-chip C/I and monitor handlers
• Synchronous Serial Control (SSC) Interface
• 8-/16-bit Local Bus Interface (LBI)
• General
Connection of up to four MUNICH32X supporting a 128-channel basic access D-channel controller
On-chip Rx and Tx data buffers 256 bytes each
HDLC protocol or transparent mode, support of ECMA 102, CCITT I4.63 RA2, V.110, X.30, DMI mode 0, 1, 2 (bit rate adaption), GSM 08.60 TRAU frames
Loopback mode, complete loop as well as single channel loop
JTAG boundary scan test
0.5 µm low-power CMOS technology
3.3 V and 5 V voltage supply
TTL-compatible inputs/outputs
160-pin P-MQFP package