PEB22811HV13

Compatible with IEEE 802.3 Ethernet MII, RMII, SMII and 7 wire interfaces
Symmetric 10 or 100 Mbit/s Ethernet speed at full duplex
Configurable as standard Ethernet PHY for use in CPE or NIC applications
MII Serial Management Interface supports full access to all internal registers and control of both local and remotedevices
No need for glue logic. Standardinterfaces provide direct connection to Ethernet MAC and PHY devices
Address filtering, self-learning and aging up to 32 addresses
Internal buffering, back pressure and IEEE 802.3x flow control capabilities
Configurable as Ethernet MAC for direct operation with standard Ethernet PHY in CPE or NIC
Supports Ethernet SNMP MIB counters
Quadrature Amplitude Modulation (QAM)
Frequency division duplexing
Symmetrical/asymmetrical line rates from below 1 Mbit/s up to 25 Mbit/s
Delivers symmetrical 10 Mbit/s payload up to a distance of 4000 ft/1200 m
Robust operation handles microinterruptions, impulse noise and severely distorted lines
Spectral allocation allows noisefree operation with xDSL, ISDN (2B1Q/4B3T), "Smartphone" digital PBX devices
Transmit Notch filter, Scrambler, Reed-Solomon Forward Error Correction (FEC) and Convolutional Interleaver with internal SRAM
Link watchdog combined with robust link configuration ensureslink establishment
Transmit power management
Low power consumption - 1.5 W including line driver
Power boost for extended reach
Power down mode with fast warm start capability (< 100 ms)
Digitally Controlled Crystal Oscillator (DCXO) for timing recovery
Embedded microcontroller for stand-alone operation
JTAG for chip level and board level testing