Features: ` NEW DMOS TOPOLOGY:
Ultra Low Dropout Voltage:
60mV typ at 100mA
Output capacitor NOT required for stability
` FAST TRANSIENT RESPONSE
` VERY LOW NOISE: 23Vrms
` HIGH ACCURACY: ±1.5% max
` HIGH EFFICIENCY:
IGND = 500A at IOUT = 100mA
Not Enabled: IGND = 10nA
` 2.5V, 2.8V, 2.85V, 3.0V, 3.3V, 5.0V, AND
ADJUSTABLE OUTPUT VERSIONS
` OTHER OUTPUT VOLTAGES AVAILABLE
UPON REQUEST
` FOLDBACK CURRENT LIMIT
` THERMAL PROTECTION
` SMALL SURFACE-MOUNT PACKAGES:
SOT23-5 and SO-8Application· PORTABLE COMMUNICATION DEVICES
· BATTERY-POWERED EQUIPMENT
· PERSONAL DIGITAL ASSISTANTS
· MODEMS
· BAR-CODE SCANNERS
· BACKUP POWER SUPPLIESA
Pinout
SpecificationsSupply Input Voltage, VIN ....................................................... 0.3V to 12V
Enable Input Voltage, VEN .................................................... 0.3V to VIN
Feedback Voltage, VFB ........................................................ 0.3V to 6.0V
NR Pin Voltage, VNR ............................................................. 0.3V to 6.0V
Output Short-Circuit Duration ..................................................... Indefinite
Operating Temperature Range (TJ) ................................ 55°C to +125°C
Storage Temperature Range (TA) ................................... 65°C to +150°C
Lead Temperature (soldering, 3s, SOT23-5, and SO-8) .................. +240°C
NOTE: (1) Stresses above these ratings may cause permanent damage.
Exposure to absolute maximum conditions for extended periods may degrade
device reliability.
DescriptionThe REG101 is a family of low-noise, low-dropout linear regulators with low ground pin current. REG101-5 new DMOS topology provides significant improvement over previous designs, including low dropout voltage (only 60mV typ at full load), and better transient performance. In addition, no output capacitor of REG101-5 is required for stability, unlike conventional low-dropout regulators that are difficult to compensate and require expensive low ESR capacitors greater than 1F.
Typical ground pin current of REG101-5 is only 500A (at IOUT = 100mA) and drops to 10nA when not in enabled mode. Unlike regulators with PNP pass devices, quiescent current remains relatively constant over load variation and under dropout conditions.
The REG101 has very low output noise (typically 23Vrms for VOUT = 3.3V with CNR = 0.01F), making REG101-5 ideal for use in portable communications equipment. Accuracy is maintained over temperature, line, and load variations. Key parameters are tested over the specified temperature range (40°C to +85°C).
The REG101 is well protected-internal circuitry provides a current limit that protects the load from damage. Thermal protection circuitry keeps the chip from being damaged by excessive temperature. The REG101 is available in the SOT23-5 and the SO-8 packages.
REG101-5 Data Sheet
