S1D15G10D08B000

• Number of liquid crystal-drive outputs: 396 segment outputs and 132 common outputs.
• Low cross talk by frame rate modulation.
• 256 color from 4096-color display or full 4096-color display. When 256 color from 4096-color display is selected: 8 gray-scale for red and green and 4 gray-scale for blue (intermediate tone is selected with the command). When 4096-color display is selected: 16 gray-scale for red, green and blue.
• Direct data display with display RAM (When the LCD is set to normally black) RAM bit Data "0000" ... OFF (Black) "1111" ...ON (Maximum RGB display) (Normally black LCD, using "inverse display" command)
• Partial display function: You can save power by limiting the display space. This function is most suited for handy equipment in the standby mode.
• Display RAM : 396 * 132 * 4 = 209,088 bits.
• MPU interface: S1D15G10 can be directly connected to both of the 8/16-bit parallel 80 and 68 series MPU. Two type serial interface are also available.
• 3 pins serial : CS, SCL and SI (D/C + 8-bit data)
• 4 pins serial : CS, SCL, SI and A0
• Abundant command functions: Area scroll function, automatic page & column increment function, display direction switching function and power circuit control function.
• Built-in liquid crystal drive power circuit: S1D15G10 is equipped the charge pump booster circuit, voltage follower circuit and electric volume control circuit.
• Oscillation circuit with built-in high precision CR (external clock signals acceptable)
• EEPROM interface functions
• Supply voltage Power for input/output system power: VDDIGND=1.7V to 3.6V Power for internal circuit operation: VDDGND=2.6V to 3.6V Reference power for booster circuit: VDD2GND=2.6V to 3.6V Power for liquid crystal drive: V3MV3=12.0V to 21.0V
• Wider operational range: 40°C to +85°C.
• Shipping from: Chip with gold bump. COF.
• Note that the radiation resistant design or light resistance design in strict sense is not employed for S1D15G10.

S1D15G10 series are the LCD drivers equipped with the liquid crystal drive power circuit to realize color display with one chip.

S1D15G10 can be directly connected to the MPU bus to store parallel or serial gray-scale display data from MPU on the built-in RAM and to generate liquid crystal drive signals independent from MPU. S1D15G10 generates 396 segment outputs and 132 common outputs for driving liquid crystal. It incorporates the display RAM with capacity of 396 × 132 × 4 (16 gray-scale). A single dot of pixel on the liquid crystal panel corresponds to 4 bits of the built-in RAM, enabling to display 132 (RGB) × 132 pixels with one chip.

Read or write operations from MPU to the display RAM can be performed without resorting to external actuating clock signals. S1D15G10 allows you to run the display system of high performance and handy equipment at the minimum power consumption thanks to its low-power liquid crystal drive power circuit and oscillation circuit.