UC1606xGAF

• Single chip controller-driver supports 65 COM x 132 SEG LCD.
• Support industry standard 8-bit parallel interface (8080 or 6800), 4-wire SPI (S8), and 3-wire SPI (S9) serial interface.
• Support four multiplexing rates (25, 33, 49,65).
• Self-configuring 6x charge pump with onchip pumping capacitor requires only 3  external capacitors to operate.
• Flexible data addressing/mapping schemes to support wide ranges of software models and LCD layout placements.
• Software programmable 4 temperature compensation coefficients.
• On-chip bypass capacitor for VLCD makes VLCD bypass capacitor optional for small LCD panels.
• On-chip Power-ON Reset and Software RESET commands, make RST pin optional.
• VDD (digital) range: 2.4V ~ 5V VDD (analog) range: 2.4V ~ 5V LCD VOP range: 6.5V ~ 12.5V
• Available in gold bump dies Bump pitch: 70uM min. Bump gap: 24uM min.

UC1606 is an advanced high-voltage mixedsignal CMOS IC, especially designed for the display needs of ultra-low power hand-held devices.

This chip employs UltraChip's unique DCC (Direct Capacitor Coupling) driver architecture to achieve near crosstalk free images.

In addition to low power COM and SEG drivers, UC1606 contain all necessary circuits for high-V LCD power supply, bias voltage generation, timing generation and graphics data memory.

Advanced circuit design techniques are employed to minimize external component counts and reduce connector size while achieving extremely low power consumption.