X9440-2.7

• Two digitally controlled potentiometers and two voltage comparators in one package
• SPI serial interface
• Register oriented format
   -Direct read/write wiper position
   -Store as many as four positions per pot
• Fast response comparator
• Enable, latch, or shutdown comparator outputs through the ACR
• Auto-recall of WCR and ACR data from R0
• Hardware write protection, WP
• Separate analog and digital/system supplies
• Direct write cell
   -Endurance100,000 data changes per bit per register
   -Register data retention100 years
• 16-bytes of EEPROM memory
• Power saving feature and low noise
• Two 10k or two 2.5k potentiometers
• Resolution: 64 taps each pot
• 24-lead TSSOP and 24-Lead SOIC packages

Temperature under bias .................-65°C to +135°C
Storage temperature ......................-65°C to +150°C
Voltage on SCK, SCL or any address input
  with respect to V_SS..................................  -1V to +7V
Voltage on V+ (referenced to V_SS) ........................+7V
Voltage on V- (referenced to V_SS) ..........................-7V
(V+) - (V-) ..............................................................12V
Any V_H.....................................................................V+
Any V_L ................................................................VLead
temperature (soldering, 10 seconds)........ 300°C

The X9440 integrates two non volatile digitally controlled potentiometers (XDCP) and two voltage comparators on a CMOS monolithic microcircuit.

The X9440 contains two resistor arrays, each composed of 63 resistive elements. Between each element and at either end are tap points accessible to the wiper elements. The position of the wiper element on the array is controlled by the user through the SPI serial bus interface.

Each X9440 potentiometer has an associated voltage comparator. The comparator compares the external input voltage V_NI with the wiper voltage V_W and sets the output voltage level to a logic high or low.

Each X9440 resistor array and comparator has associated with it a wiper counter register (WCR), analog control register (ACR), and eight 6 bit data registers that can be directly written and read by the user. The contents of the wiper counter register controls the position of the wiper on the resistor array. The contents of the analog control register controls the comparator and its output. The potentiometer is programmed with a SPI serial interface.