Published:2009/7/20 3:39:00 Author:Jessie | From:SeekIC
10 kHz frequency-to-voltage convener. The input signal should be a pulse train or square wave with characteristics similar to TTL or 5-volt CMOS outputs. Minimum pulse width is 40 μs. Full scale output is 1 volt for a 10kHz input. To trim first set Vos to midrange and trim the 2K pot for 1-volt output. Then apply a 10-hertz waveform and trim Vos for a 10 mV output (courtesy Analog Devices, Inc.).
Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/A-D_D-A_Converter_Circuit/10_kHz_frequency_to_voltage_convener.html
Print this Page | Comments | Reading(3)
Code: