PROGRAMMABLE_ACTIVE_FILTERS

Published:2009/7/6 5:16:00 Author:May | From:SeekIC

This is a second-order, low-pass filter with programmable cutoff frequency. This circuit should be driven from a low-source impedance since there are paths from the output to the input through the unse-lected networks. Virtually any filter function which can be constructed with a conventional op amp can be made programmable with the HA-2400. A useful variation would be to wire one channel as a unity gain amplifier, so that one could select the unfiltered signal, or the same signal filtered in various manners. These could be cascaded to provide a wide variety of programmable filter functions.



Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Basic_Circuit/Filter_Circuit/PROGRAMMABLE_ACTIVE_FILTERS.html

Print this Page | Comments | Reading(3)