Published:2011/9/18 23:03:00 Author:Ecco | Keyword: Hard disk, control circuit , original program | From:SeekIC
In the program, all hardware-related parameters is defined at the beginning of the program, when it is transplanted to other types of microcontrollers, the pins defination needs to be simplily changed. When it is used, the corresponding parameters need to be modified according to your hard (there are comments in the program). Firstly, you should connect the circuit (very simple), then the chip is burned into the process. Firstly ,the hard is connected to power, and then you can open any serial debugger to set the baud rate in 57600bps, and then you can run the microcontroller.
Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Basic_Circuit/Hard_disk_control_circuit_and_the_original_program.html
Print this Page | Comments | Reading(3)
Code: