The interface circuit of pressure transmitter ( wideband strain signal conditioner 1B31)

Published:2012/9/25 21:35:00 Author:Ecco | Keyword: interface , pressure transmitter , wideband, strain signal , conditioner | From:SeekIC

The interface circuit between typical pressure transmitter ( such as Dynisco's 800 series of pressure transmitter ) and 1B31 is shown as the figure. 1B31 outputs +10 V excitation voltage, the pressure transmitter outputs 30mV voltage in full scale. The gain of 1B31 is set 333.3 times to convert the 0 to 10,000 pounds / inch 2 pressure into 0 ~ 10V output. In order to eliminate ground loop, the signal return side and shielded cable must be grounded in the same place. S is the calibration switch, R is the branch calibration resistor to calibrate 80 % of full-scale output point.



Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Basic_Circuit/The_interface_circuit_of_pressure_transmitter__wideband_strain_signal_conditioner_1B31.html

Print this Page | Comments | Reading(3)