The roadblocks flashing alarm circuit ( 4 )

Published:2012/11/5 20:48:00 Author:Ecco | Keyword: roadblocks flashing, alarm | From:SeekIC

Road blocks flashing warning light using battery is shown in the figure, and it can be used local road facilities without AC power for roadblocks alarm. NE555, RP1 , RP2 , C1 , RL and RL form a a light -controlled self-excited multivibrator. Due to light exposure in daytime, it is in low resistance, NE555 forces reset terminal ④ feet level to be less than 0.4V, and the NE555 is mandatory reset, output end ③ feet is constant low, then VT1 and VT2 are cutoff, warning lights E does not shine. Due to RL has no light exposure in nighttime, it shows a high resistance, then it is divided by RP2 to make ④ feet level increase, when it is greater than 0.4V, you can lift the blockade on the circuit, the circuit is start-up.



Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Control_Circuit/Alarm_Control/The_roadblocks_flashing_alarm_circuit__4_.html

Print this Page | Comments | Reading(3)