LED VoltMeter circuit

Published:2012/9/27 21:36:00 Author:muriel | Keyword: LED, VoltMeter | From:SeekIC

Here is a Simple LED Voltmeter to Monitor the charge level in Lead Acid Battery or Tubular battery. The terminal voltage of the battery is indicated through a four level LED indicators.The nominal terminal voltage of a Lead Acid battery is 13.8 volts and that of a Tubular battery is 14.8 volts when fully charged. The LED voltmeter uses four Zener diodes to light the LEDs at the precise breakdown voltage of the Zener diodes. Usually the Zener diode requires 1.6 volts in excess than its prescribed value to reach the breakdown threshold level. When the battery holds 13.6 volts or more, all the Zener breakdown and all LEDs light up. When the battery is discharged below 10.6 volts, all the LEDs remain dark. So depending on the terminal voltage of the battery, LEDs light up one by one or turns off. LED VoltMeter Circuit Schematic



Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Control_Circuit/LED_VoltMeter_circuit.html

Print this Page | Comments | Reading(3)